4
2.1 The machine is an electrical household appliance, therefore general electric safety rules should be fulfilled
during its operation.
2.2 The appliance is not intended for use by the persons (including children) having lowered physical, sensual or
mental abilities, or if they have no experience or knowledge, if they are not under control or have not been instructed
about the use of the appliance by a person responsible for their safety.
Children must be under control in avoidance of any playing with the appliance.
2.3 By the type of protection from electricity shock the machine is related to class I.
2.4 A double-pole socket having the earthing contact for connection of the machine must be located at a place
accessible for urgent disconnection of the machine from the electrical mains.
2.5 Before connection of the machine to the electrical mains absence of damages of the power supply cord
should visually be checked. The cord must not be twisted and compressed.
When the power supply cord is damaged in order to avoid any danger it must be replaced by the manufacturer
or a service company.
2.6 Safety precautions should be observed during handling and transportation of the machine as it has a big
mass.
2.7 IT IS PROHIBITED to install the machine outside the premise so that not to subject it to atmospheric
impact.
2.8 IT IS PROHIBITED to operate the machine without installation of plugs in accordance with clause 3.1.2.
2.9 When the machine is connected to the cold water supply network only a new filling hose should be used
which is included to a supply set.
2.10 IT IS PROHIBITED to use in the machine the substances containing solvents, as there is a danger of release
of poisonous gases, machine damage, ignition and explosion.
2.11 In the process of washing it is not recommended to touch the machine door glass, as it is heated and may
become the reason of a fire.
2.12 After the end of a washing the machine is to be switched off, disconnected from the electrical mains, the
plug is to be pulled out of the socket, and the water supply cock is to be closed (see fig. 8).
2.13 For provision of electrical and fire safety the following IS PROHIBITED:
— to connect the machine to the electrical circuit having malfunctioned protection from current overloads;
— to use a socket without an earthing contact for machine connection;
— to use adapters, multi-seat (having two or more points of connection) sockets and elongation cords for
machine connection to the electrical mains;
— to disconnect the machine from the electrical mains by pulling the supply cord;
— to insert and pull out the power supply plug from the socket, as well as to touch the operating machine
with wet hands;;
— to wash the machine under a water jet;
— to independently repair and introduce amendments to the machine design, as well as to its water and electric
power supply. This may result in serious damages of the machine and deprive of the warranty repair. The repair must
only be performed by a qualified mechanical expert of a service company.
2.14 If any malfunction is found in machine operation related to electrical crackling, smoking, etc. The machine
should immediately be disconnected from the electrical mains, by pulling the plug from the socket, the water supply
cock should be closed, and a mechanical expert of a service company should be called.
In case of a fire the machine should immediately be disconnected from the electrical mains, the water supply
cock should be closed, measures are to be taken for fire extinguishing and a fire brigade is to be called.
