642850

Exquisit WA 6014 A plus Manual

42
Zoom out
Zoom in
Previous page
1/64
Next page
42
EN
nut and disconnecting the hose from water delivery cock. Connect the filling hose to the water conduit.
Open the water delivery cock.
Charge the respective dispenser drawer section with a detergent designed for automatic washing
machines and a special treatment. Close the drawer carefully.
Insert the plug in receptacle.
Switch on the Machine by pushing the button . The drum’s booster light goes on. Make a washing
program selection. Program name and its basic parameters (maximal temperature of washing, number of
revolutions per minute during spin, electrical power, water consumption, and washing duration readings)
are highlighted in display indication zones.
Perform temperature, spin RMP selection and assign auxiliary operations. Thus, indicators of assigned
program parameters will be highlighted on the display.
Averaged time of selected washing program duration is displayed.
The real time of a washing may differ from the displayed one as it depends on water temperature and pr-
essure in water-supply line, weight of laundry, type of good’s cloths, voltage magnitude in electric main, etc.
CAUTION! Nonconcurrency in displayed reading of time up to the end of washing with its real
termination time is admitted.
Prior to start the Machine’s operation under the selected program, push button (START/PAUSE).
The indicator on button goes on and the sound signal sounds. Blocking device to prevent the door opening
is actuated. If the door has a poor closing, the washing will not start and there will be a message “DOOR
OPEN”.
If the time of the delayed washing start has been assigned, time reading begins to blink slowly in
E zone of the display. This time reading declines with the interval in one hour and the indicator in zone
D of the display is on. Upon expiration of the set time, the indicator fades and the Machine starts to run
upon selected program. Time remaining up to washing program counts down in zone F.
During Machine’s running, selected program name and a name of a main operations carried out in
present time (PREWASH, SOAKING, WASHING, RINSING, RINSE HOLD, FINAL SPIN, PROGRAM END) highlights
one at a time on the display with an interval of 5 s.
CAUTION! It is not recommended to use the water conduit when the water is filled in the Machine
during washing program execution. Quantity of filling water may be excessive or poor because of
pressure disturbance in the water conduit.
On completion of the last washing operation, after expiry of aprox. 2 min, blocking device of the door
is released. Triple sound signal sounds by a five times (with an interval of 1 min). Message “PROGRAM END”
appears on display and indicator on the button START/PAUSE fades.
On completion of the washing, switch off the Machine by pushing the button . Draw the plug connector
of the power cord out of the receptacle and close the water delivery cock.
Open the door and extract the laundry.
Pull out the drawer slightly and remain the door ajar till the inners Machine’s parts became dry. To prevent
an odor in the Machine, the door should be remained ajar up to the next washing. It is recommended to fix
up blocking of the door against closing.
CAUTION! Ceasing of energizing in electric main during washing has no affects on following
operation of the Machine. On renewal of energizing in electric main, the Machine proceeds program
execution from the stop time.
ALTERATION OF PROGRAM
To alternate the previously selected program, hold the button
R
pressed for 3 s up to triple sound signal
sounding. The Machine shuts down and the program is cancelled. Proceed the new Machine’s powering.
Check the detergent for presence in the dispenser drawer designed for detergents and recharge if needed.
If it is necessary to open the door, drain the water by pushing button
«
and than, select program
“Drainage”.
If it is necessary to stop Machine’s running without alteration of program (for instance, to add some
laundry in the drum), hold the button START/PAUSE for 2 s up to indicator’s on the button START/PAUSE
blinking appearance and sound signal sounds. Countdown on the display will stop and on expiry of aprox.
2 min the door’s blocking device will be released.
It is impossible to stop the Machine running under the programs “DELICATES, “WOOL”, “HAND WASH”,
“MIXED” as the washing with great quantity of water is provided. The indicator does not blink and blocking
device will not be released.
If it is necessary to open the door at that program execution, perform the water drainage. Push the
knob and than select “Drain” program.
CAUTION! Do not open the Machine’s door if the water level in the drum detects visually through
the door’s glass.
… 42 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Exquisit WA 6014 A plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Exquisit WA 6014 A plus in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 6,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info