783557
3
Zoom out
Zoom in
Previous page
1/10
Next page
3
Supplied
1 PORTAFILTER
1 FILTER BASKET SPRING
1 1 CUP FILTER BASKET 7g
1 2 CUP FILTER BASKET 14g
1 2 CUP SPOUT
Optional
1 CUP SPOUT
POD FILTER H-17, H-19
The manufacturer reserves the right to make any changes to the machine for improved
performance without prior notice.
PLEASE READ THIS HANDBOOK CAREFULLY
BEFORE USING THE MACHINE
Please check the machine specification plate to ensure that the electrical specification matches your
supply. The supply should also include an electrical earth/grounding and correct over-current protection.
In the event that the power cord is damaged in any way, it will need to be replaced by the manufacturer,
distributor, or qualified electrician in order to avoid possible injury.
2. INSTALLATION AND START UP
THE MACHINE SHOULD BE PLACED ON A LEVEL SURFACE FOR CORRECT OPERATION.
Before use, fill the water tank (8) up to the water viewfinder (1) being careful not to overfill or spill water
into the machine. It is recommended that only softened water is used in order to minimize limescale and
mineral build-up inside the machine.
Open the steam knob to vent any air from the boiler and switch the machine on (2). The boiler will start to
fill automatically, if in 45 seconds the boiler is not full, the process will stop in order to protect the
heating element, and an alarm will be indicated by the alarm LED or the keypad LED’s flashing. If the
alarm LED is flashing, then turn the machine off (2), wait 10 seconds and turn the machine on again (2),
filling will now continue. Make sure the water intake hose (has a filter on it) is all the way at the bottom
of the reservoir to keep air from entering the intake hose.
When the machine has finished the initial filling process of the boiler, the machine will then start the
heating process. Close the steam knob and lock the group handle into the group head as the machine is
heating up. It will take 8 to 10 minutes to heat up to the proper boiler temperature/pressure for brewing.
You may want to preheat the brew group by running a blank shot or two by pressing the brew switch (9)
or the (*) key on the keypad. This will turn on the pump and run hot water through all of the brewing
components to heat them before making the first coffee.
Fig. 1
CORRECT FITTING OF THE PORTAFILTER
INTO THE GROUP HEAD.
Insert the portafilter at point A and
match the lugs on the bowl to the slots
inside the group head. Turn the handle
from left to right until it reaches point B
and is secured in the group head.
A.
B.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Expobar Office Lever at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Expobar Office Lever in the language / languages: English as an attachment in your email.

The manual is 0.64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info