682440

Everglades EVTD301 Manual

11
Zoom out
Zoom in
Previous page
1/33
Next page
2|
Unpacking and moving the refrigerator
WARNING
Move the refrigerator with two or more people. Back injuries or other injuries might otherwise occur.
Remove the tape and labels from your refrigerator before using it (except for the data plate). Rub any tape or glue that is left
firmly with your thumb to remove it. You can also remove tape or glue residue easily by rubbing the glue with a little washing
liquid on your fingers. Rinse it off with warm water and dry the refrigerator. Do not use sharp instruments, alcohol, flammable
liquids or abrasives to remove tape or glue. These products can damage the surface of your refrigerator. Make sure that the
refrigerator is in an upright position when it is moved. Never allow the refrigerator to tilt more than 45 degrees.
Cleaning before use
Clean the interior of your refrigerator with soda and lukewarm water after you have removed all packaging materials, before
putting the refrigerator into use.
Safety regulations
WARNING
Keep flammable materials and vapors, such as petrol, away from the refrigerator. Serious injuries might otherwise occur.
Ensure that your refrigerator is well ventilated, with at least 20 cm of space on each side between the walls, 10 cm
between the back of your refrigerator and the wall, and 30 cm between the bench top and the roof or ceiling.
If you place the refrigerator next to a solid wall, allow sufficient space on the hinge side for the door to open.
Never put your refrigerator close to heat sources or in direct sunlight.
WARNING
• Do not remove the earthed plug.
• Do not use an adapter.
• Do not use an extension cord.
• Not following these instructions can result in serious consequences.
• Make sure you have the correct electrical connection.
Recommended connection
The refrigerator may only be connected to a properly earthed socket. A properly earthed power supply of 220/240 Volt / 50
Hz AC with only a 10 ampere fuse is required. The use of a separate fuse for this appliance is recommended. Use a socket
outlet that cannot be switched off with a switch or pull.
NOTE
When you install or clean the refrigerator, or remove or replace the light, turn the thermostat to OFF and disconnect the
power supply from the appliance. When you are ready, reconnect the refrigerator and set the thermostat to the desired
setting.
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Everglades EVTD301 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Everglades EVTD301 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 13,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info