•Use the stove only as described in this manual. Any other use not recommended by the manufacturer may cause fires or accidents to people.
•Make sure that the electrical power available corresponds to the value indicated on the data plate (230V~/50Hz).
•This appliance is not a toy. Make sure children are not left unattended and do not use the appliance as a toy.
•This device is not intended for use by persons (including children) with reduced physical or mental capacity, or without specific experience and knowledge,
unless supervised or duly instructed on the use of the appliance by a person responsible for their safety.
•Disconnect the appliance from the mains when not in use or during cleaning operations.
•Never block the combustion air inlets and fume outlets.
•Since the stove is fitted with electrical components, do no touch it with wet hands
•Do not use the appliance in case of damaged cables or plugs. The device is classified as type Y: the power supply cable may only be replaced
by a qualified technician. Should the power supply cable be damaged, it can be replaced only by the manufacturer or by its technical assistance
service or by a similarly qualified person.
•
CAUTION! DO NOT TOUCH the FIRE DOOR, the GLASS, the HANDLE OR THE FUME OUTLET PIPE DURING OPERATION if not wearing
adequate protective devices as they become extremely hot!
•Keep inflammable materials, such as furniture, cushions, pillows, blankets, paper, clothing, curtains, etc., at least 1.5m away from the stove front and
30cm from thestove sides and back.
•Do not use the stove in dusty environments or wherever inflammable gases are generated (e.g. in a workshop or garage).
•The stove that is covered by or in direct contact with flammablematerials, including curtains, blankets, etc., during normal operation may result in a fire
hazard. KEEP THE APPLIANCE AWAY FROM THE MATERIALS MENTIONED ABOVE.
•Do not immerse the cable, plug or any other appliance component in water or other liquids.
•Do not use the stove in dusty environments or whereverinflammable gases are generated (e.g. in a workshop or garage).
•The stove is fitted with components that generate arcs and sparks. Do not install the stove in areas posing a significant fire or explosion hazard due to a
high chemical substance concentration or to a high humidity level.
•Do not use the appliance close to bathtubs, showers, basins, sinks or swimming pools.
•Do not install the appliance underneath an air vent. Do not install the stove outdoors.
•Do not repair, disassemble or modify the appliance. The appliance is not fitted with components that can be repaired by users.
•Turn off the stove, disconnect it from the mains and wait until it has cooled down completely before performing any maintenance operations.
•WARNING: DISCONNECT THE STOVE FROM THE MAINS BEFORE PERFORMING ANY MAINTENANCE.
•CAUTION! This stove works exclusivelywith wood; DO NOT USE FUELS OTHER THAN WOOD: any other material will be burned. It will cause
failure and malfunction of the appliance.
•Store the wood in a cool and dry place: storage in overly cold or humid places can result in a reduction in the heat output of the stove.
•Clean the firebox regularly each time it is used.
•Open the firebox only upon refuelling or removal of residues to prevent fumes from escaping.
•Do not use the appliance as waste incinerator or for any other purpose other than the intended one.
•Do not use liquid fuels.
•Do not modify the appliance without prior authorisation.
•Use only original spare parts recommended by the manufacturer.
•The wood log should have maximum 330mm in length and a maximum moisture content of 8%;
•Make sure that the stove is transported in compliance with safety regulations. Avoid any improper transfers or knocks that may damage the tiles, stone
finishes or the structure.
•The metal structure is coated using high temperature paints. When using the appliance for the first few times, unpleasant odours may be given off due
to the paint of the metal parts that is drying: this is in no way dangerous and in such case, simply ventilatethe premises. After the first heating cycles,
the paint will reach its maximum adhesion and all its chemical and physical features.
•CAUTION! Being a heating appliance, some parts of the stove can become extremely hot. For precisely this reason, we advise that you take
extreme care during operation.
WHEN THE STOVE IS WORKING:
•do not open the door;
•do not touch the door glass since it becomes extremely hot;
•keep children away from it;
•do not touch the fume outlet;
•do not pour any liquid inside the firebox;
•do not perform any maintenance operations if the stove is not cold;
•only qualified technicians are allowed to perform any operation;
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Eva Calor Wanda at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Eva Calor Wanda in the language / languages: English as an attachment in your email.
The manual is 5.01 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.