6 USE
All local regulations, including those relating to national and European regulations, must be
observed when installing the unit.
Improper installation or use of the device can result in forfeiture of the warranty.
Do not use the unit as an incinerator or in any other way other than that for which it was designed.
No other fuel besides wood pellets must be used.
Do not use liquid fuels.
The device, especially the external surfaces, gets very hot to the touch when in use. Handle with
care to avoid burns.
Do not make any unauthorised modifications to the device.
Only use original replacement parts recommended by the manufacturer.
In general
- Make sure that the room where the stove is to be installed offers sufficient ventilation (see section
"1.3 External air intake vent").
- Make sure that all exhaust system joints are hermetically sealed with silicone (no cementing), are
resistant to heat (250 ° C) and are not damaged.
- Periodically check (or have someone check) the cleanliness of exhaust fumes.
- CAUTION: keep all flammable products well away from the stove when it operating
(MINIMUM: 100 cm from the front wall).
- CAUTION: to prevent the escape of fumes, the combustion chamber must be kept closed
except during cleaning operations, to be carried out with the stove off.
- CAUTION: removing the safety guard inside the tank is strictly prohibited.
- CAUTION: in the event of pellet supply while the stove is on, make sure that pellets are not
finished and that the flame remains present in the brazier. Also avoid the fuel sack from
coming into contact with hot surfaces.
- CAUTION: remove any residue of unburned pellets caused by failed ignitions before you
start the stove again.
- CAUTION: if during the ignition phase, the stove does not start and you notice a lot of
smoke in the combustion chamber, immediately turn off the stove and replace pellets in
use, as these may be too high in moisture. Forcing ignition could make your stove a hazard.
- CAUTION: if during cleaning, you find traces of spongy or hard (though not ash) pellets,
replace the pellets being used as this residue may come from scraps of low quality sawdust
not usable in this type of stove. Forcing ignition can cause a fire or strong production of
fumes in the chimney.
- CAUTION: monitor proper combustion of the pellets in the brazier. If you should detect
accumulations of unburned pellets, IMMEDIATELY TURN OFF the stove and contact the
service centre.
- CAUTION: exercise extreme caution in the presence of children, to prevent them from
standing in front of the stove.
