591712
20
Zoom out
Zoom in
Previous page
1/32
Next page
- 20 -
Step 3
3-2 Place the gas bottle container over the frame.
G = gas bottle container
Step 4
4-5 Screw the 3 supporting bolts for the reflector
screen into the middle of the 3 headless screws.
4-6 Screw the headless screws (with the washer in
between) with the other side held fast into the
upper cap of the flame screen.
4-7 Secure the rubber hose for the pressure regulator
to the underside of the burner and allow this to drop
into the stand.
4-8 Screw the gas hose nut tight to the burner’s gas
inlet.
4-9 Place the burner with the operation panel and the flame screen on the
stand and secure with 4 M6 x 10mm bolts.
H = stay bolt I = headless screw J = washer K = gas inlet L = swivel nut
M = hose N = bolts
Step 5
5-4 Place the 3 segments that make up the reflector cap with the 9
bolts and wing nuts on the central plate and secure.
5-5 Screw the 3 washers over the pins on the flame screen and
place the reflector cap above the burner so that the pins fit
through the holes and the cap rests on the bolts.
5-6 Place 3 washers over the headless screws and secure this
whole construction above the cap with the 3 wing nuts.
P = wing nut Q = central plate R = segment
S = bolt
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Eurom THG12000 RVS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Eurom THG12000 RVS in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,99 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info