510033

Eurom SHOE-DRYER 350 Manual

12
Zoom out
Zoom in
Previous page
1/32
Next page
12
Location and Connection
Remove all packaging material and keep out of reach of children. After removing packaging,
check the appliance for damage or other signs that could indicate a fault/defect/malfunction. In
case of doubt, do not use the appliance, but contact your vendor for inspection or replacement.
1 = drill hole 2 = plug 3 = screw 4 = screwdriver 5 = attachment block
Select a suitable place for the device, taking into account the safety instructions. The BK2002T
has to be hung from a wall and therefore may not be used in a lying, leaning, hanging or standing
position! The wall on which the device is hung has to be firm, flat and perfectly vertical and made
from non-inflammable material that cannot melt. Hang the shoe dryer in such a position that the hoses
are able to hang downwards freely and without any kinks. The ideal position is generally at a height that the
hoses do not quite touch the floor, then they can easily be inserted into shoes/boots (drill holes 96 cm above
the floor).
Drill 3 holes in the wall at the selected spot: 2 horizontal to one another with a distance of 19 cm and one 23
mm higher at an equal distance to the two other holes (picture B). Insert plugs into the holes and insert
screws into the first two holes (picture C). Leave the screws protruding by 5 mm (picture D).
Hook the shoedryer using the suspension eyes over the screws and pull the shoedryer downwards (picture
E). Secure the shoedryer by screwing the attachment block into the third screw hole: the attachment block
which has a hole in it to be placed against the wall, with the flat square pointing downwards, holding the
heater securely (picture F).
Switching on and operation

Fully unwind the electric cable and insert the plug into a suitable 220/240V socket.
Place the shoes/boots that are to be dried underneath the appliance and insert the drying hoses into the
boots/shoes. A maximum of 4 items can be dried at the same time. If you only have two items, if the size
permits this, you can place two hoses in one shoe/boot. However, make sure that the warm air that is blown
out is then able to escape again; therefore the hoses must not be inserted too tightly into the boot/shoe,
otherwise the appliance may overheat!
By now turning the ON/OFF button anticlockwise to ON, you switch on the appliance. It will draw in air from
the rear, heat this up in the appliance, blow this out through the hoses which will dry out the shoes/boots.
During operation, the indication light will be illuminated.
You turn off the appliance by turning the ON/OFF button clockwise to OFF.
Timer:
The heater is equipped with a timer. When you wish to use that, do not turn the ON/OFF button to ON, but from
the OFF position clockwise to the required number of minutes of operation (max. 120). The heater will now switch
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Eurom SHOE-DRYER 350 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Eurom SHOE-DRYER 350 in the language / languages: English, German, Dutch, French, Swedish as an attachment in your email.

The manual is 0,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info