667891

Eurom SANICOMFORT 400 Manual

20
Zoom out
Zoom in
Previous page
1/52
Next page
20
Turn the heater on by pushing the on/off switch to ‘on’ (I pushed in). The control light will come
on, the display will light up and the ambient temperature will show on the display.
Pressing on the + or - button will display the set temperature (which will flicker for a few
seconds). You can adjust this a degree higher or lower by pressing the + or - button until the
desired temperature is set. If the desired temperature is set higher than the ambient
temperature, the heater will start to heat. The temperature will be maintained as a result of
the heater switching itself on and off.
Pressing the timer button sets a specific time. The set time will flicker for a few seconds on
the temperature display. Every time you press the button, the time will increase by 2 hours,
from 0 hours (0H) to 2, 4, 6 and 8 hours. Pressing it again will reset it to zero.
To switch off, click the ON / OFF-switch to off. The heater switches off. Unplug.
Safety features
Overheating safeguard
In case of internal overheating, the overheating safeguard will switch the heater off. This may
occur if the heater cannot give off enough heat or if it does not get enough fresh air. As
mentioned above, this is generally caused by (partially) covering the heater, installing the heater
too close to a wall or something similar. When the heater has cooled down sufficiently, it will in
principle start again automatically, however if you do not remove the cause of the cut-off then
this will probably be repeated. Regular overheating can give rise to irreparable damage.
When the overheating safeguard switches the heater off, set the switch to ‘O’ (off), unplug and
allow the heater to cool down. Remove and/or amend the cause of overheating and reuse the
heater as normal. If you cannot find a cause and overheating recurs, stop using the heater, and
take it in for inspection/repair.
Cleaning and Maintenance
Keep the heater clean. Deposits of dust and dirt in the appliance are a common cause of
overheating so these should be removed regularly. Switch off the heater, remove the plug from
the socket and allow the heater to cool down before cleaning or carrying out maintenance work.
Wipe the outside of the heater regularly with a dry or slightly damp cloth. Do not use
aggressive soaps, sprays, cleaners or abrasives, waxes, polishes or chemical solutions!
The heater contains no other parts which need maintenance.
Do not dispose of heater with household waste when it becomes worn or damaged beyond
repair. Take it to your local authority's collection point for electrical appliances where any
reusable materials will be collected and redistributed.
CE-statement
Euromac bv, Genemuiden-NL hereby declares that the EUROM electrical convector heater,
type SANI-COMFORT 400, complies with the LVD guideline 2006/95/EG and the EMC
guideline 2004/108/EC and meets the following standards:
EN 55014-1 :2006/+ A1 :2009/+A2 :2011 EN 60335-2-30 :2009+A11 :2012
EN 55014-2:1997/+A1:2001/A2:2008 EN 60335-1 :2012+A11 :2014+AC :2014
EN 61000-3-2 :2014 EN 62233 :2008
EN 61000-3-3 :2013
Genemuiden, 31-08-2015
W.J. Bakker, alg.dir.
… 20 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Eurom SANICOMFORT 400 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Eurom SANICOMFORT 400 in the language / languages: English, German, Dutch, French, Swedish as an attachment in your email.

The manual is 1,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info