The operational panel also has 7 indicator lights that show which
settings are active and a display (Led display) that shows any values
set.
Before using the air conditioner, check:
That it has been installed according to safety instructions
That it is not damaged or broken
That the electrical socket that you wish to use has the same
voltage as is given on the unit’s specification plate (220-240V /
50Hz)
That no other devices are connected to the same socket
If this has all been checked, you can insert the plug into the socket.
Start the unit by pressing on the ON/OFF button.
Use the Function selector button to choose a specific function:
cool, dehumidify or fan. Every time you press the button, the function
changes. The lights show which function is active. If you are cooling
or dehumidifying, wait for up to 3 minutes after switching on or off
before switching the unit on or off again. The compressor needs this
time to recover.
Use the Fan speed button to set the fan to high or low.
If you wish to cool, you can use increase or decrease the
temperature using the Temperature up/down buttons. Every time you
press these buttons, the set temperature will increase or decrease by
one degree. The display shows the value set. The temperature can
be set to between 16 and 31°C.
If you wish to dehumidify, press the function selector button until the
‘dehum’ light comes on. Check that the water outlet hose is correctly
connected, see page 6! The temperature will be automatically set to 2
degrees below room temperature (16°C to 31°C).
The fan speed will be automatically set to ‘LOW’.
Using the functions ‘cooling’ and ‘dehumidifying’, the apparatus will
occasionally stop in order to protect the compressor. The apparatus
will restart after approx. 3 minutes. Do NOT change any settings in
the meantime!
If you set the apparatus to ‘cooling’ or ‘dehumidifying’, it will
continuously operate unless:
The room temperature becomes lower than the set temperature.
The timer is set to a final time.
