INSTALLATION
The EUROM PAC7.2 and PAC9.2 are mobile air conditioning/
dehumidifying units that can be moved from room to room. Install as
follows:
Remove all packaging material and ensure that the unit remains
in an upright position.
Before use, check that all accessories are present and that there
is no damage to the accessories or the unit itself. Do not use a
damaged unit; take it back to your supplier!
Place the unit on a sturdy, flat, dry and horizontal base near an
electrical socket and a discharge point for hot air, e.g. a window
that can be opened slightly. Make sure that the unit has at least
50 cm of free space on all sides and take all safety instructions
into account.
To use the dehumidification function, connect the water
drainage hose to the water drainage point (9). This hose should
lead to a bucket or drain. The hose should not run upwards! Your
unit is now ready for use.
In order to use the cooling function, you do not need to connect
the water drainage
hose. Place
window panel in
the window
opening, see
diagram. The
length of the
window panel can
be adjusted from
67.5 to 123 cm.
Screw on the connector for the air conditioner on one end and the
connector for the window panel on the other end of the outlet
hose.
Slide the connector for the air conditioner into the appropriate slot
on the rear of the unit.
Secure the other end of the outlet hose in the window panel
opening so that it can remove hot air outside.
You can also hang the outlet hose out of an open window; this
method is less efficient however.
Avoid bends or pinches in the pipe. These will lead to a build up
of damp, waste air which can cause leaks, overheating or lead to
the air conditioning unit switching off.
