Operating
• Check that the details on the data plate correspond to those of the electrical supply
which you wish to use for the fireplace. Do not use the same connection for any other
equipment.
• The control switches and the thermostat knob are located at the rear of the heater.
• By pressing the bottom switches you will make the following happen:
Switch 1: switch on the power supply to the heater and the flame
effect (without heating) (O depressed is OFF - I depressed
is ON).
Switches 1+2: switch on 1000 Watt heating, with flame effect
Switches 1+2+3: switch on 2000 Watt heating, with flame effect
• Check whether switch 1 is set to OFF (O depressed)
• Connect the plug to an earthed power outlet.
• Turn the thermostat dial to maximum (clockwise as far as possible).
• Press switch 1 and, depending on what you want, switches 2 and 3 to start using the
heater.
• Once the desired temperature is reached, turn the thermostat dial back slowly until
you hear a click. The temperature is now set. The heater will automatically switch on
and off to maintain the set temperature. To set a higher or lower temperature, turn
the thermostat dial either clockwise or anticlockwise.
• Switch off the heater by resetting all switches to the OFF position. Remove the plug
from the power outlet; do this whenever the heater is not in use!
Safeguards
The Orsa atmospheric fireplace is equipped with an overheating safeguard. The
overheating safeguard switches the heater off if it overheats internally. This may occur if
the heater cannot give off enough heat or if it cannot draw in enough fresh air. As
mentioned above, this is generally caused by (partially) covering the heater, obstructing
the air intake and/or outlet grills or installing the heater too close to a wall or something
similar.
