591328

Eurom Oil panel heater 400 Manual

17
Zoom out
Zoom in
Previous page
1/44
Next page
clamp plates and radiator and screw the upper brackets tightly into position. Place the
radiator in the lower bracket again and now screw the clamp plates, using the 2x2 short
screws, onto the upper brackets (top of the radiator in the channel on the clamp
plates).
Check that the radiator is securely attached and that it cannot be pulled or slide out of
the brackets without the use of a screwdriver.
Your heater is now ready for use.
Set-up and Operation
Set the power switches to OFF and the thermostat dial to maximum (HIGH).
Plug in the heater.
Turn the heater on by switching the ON/OFF switch to ON. The light will go on and the
heater begins to work.
When the room has reached the desired temperature, turn the thermostat button to the
left (towards minimum) until you hear a click. The light will go out. When the button is
in this position, the heater will maintain the current temperature by regularly switching
on and off. The light will go on when the device switches on. Turning the thermostat
button to the right/left increases/decreases the set temperature.
To switch off, turn the power switches to OFF (off). The heater switches off. Unplug.
Note! It takes a long time for an oil filled radiator to cool down. Give the radiator
sufficient time to cool down before touching or moving (use handle!).
Safety features
The heater is fitted with a tipping safeguard which automatically shuts off the appliance if
it inadvertently falls over. When the heater is returned to its upright position, it will resume
functioning as normal but, before reusing, switch off, unplug and check for damage. Do not
use the heater if it is damaged or malfunctioning, but have it inspected/repaired!
In case of internal overheating, the overheating safeguard will switch the heater off. This
may occur if the heater cannot give off enough heat or if it or cannot draw in enough fresh
air. As mentioned above, this is generally caused by (partially) covering the heater or
installing the heater too close to a wall or something similar. When the overheating
safeguard has switched the heater off, you need to set the output-button to ‘OFF’ (off) and
unplug the heater. Give the heater time to cool down, remove the source of the
overheating and use as normal. If the problem persists or if you have not been able to
trace the source of the overheating, turn the heater off immediately and unplug. Contact a
service point to have the heater repaired.
Cleaning and Maintenance
Keep the heater clean. Deposits of dust and dirt in the appliance are a common cause of
overheating so these should be removed regularly. Switch off the heater, remove the plug
from the socket and allow the heater to cool down before cleaning or carrying out
maintenance work.
Wipe the outside of the heater regularly with a dry or slightly damp cloth. Do not use
aggressive soaps, sprays, cleaners or abrasives, waxes, polishes or chemical
solutions!
The heater contains no other parts which need maintenance.
At the end of the season, store the cleaned heater in the original packaging if possible.
Store upright in a cool, dry and dust-free place.
Do not dispose of heater with household waste when if becomes worn or damaged
beyond repair. Take it to your local authority's collection point for electrical appliances
where any reusable materials will be collected and redistributed.
… 17 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Eurom Oil panel heater 400 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Eurom Oil panel heater 400 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 0,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info