510022

Eurom E-convect Manual

13
Zoom out
Zoom in
Previous page
1/20
Next page
After removing packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact your vendor for inspection
or replacement.
Do not use the heater before it has been installed in accordance with the following instructions!
This radiator can be used as a free-standing device or mounted on the wall.
Free-standing:
Secure the feet supplied to the underside of the radiator (see diagram):
Place both feet on the ground, ± 50 cm. apart, screws to the back
Slide the heating panel into the slot of the feet, so the panel sticks out ±
5 cm on each side. The switch is at the top right, at the rear (see fig. on
front of this booklet).
Secure both screws and thereby clamp the panel in the feet.
Your E-convect is ready to use.
Mounted on the wall:
The heater must be at least 150 mm removed from all objects, walls, etc.; the distance to the floor must be
at least 200 mm and there must be at least 150 mm above the heater.
Choose a firm, smooth, vertical wall of heat resistant material.
Mark the places where the holes are to be drilled (fig. 1).
Drill the holes at the marked places with the drill provided (fig. 2).
Tap the distance plugs as far as possible into the drill holes; the E-convect will now keep sufficient
distance to the wall (fig. 3).
Hang the E-convect with its 4 holes over the 4 plugs on the wall (fig. 4). Check whether the distance to
the floor is at least 20 cm!
Now screw the 4 bolts through the E-convect into the plugs (fig. 5)
Press the cover caps over the heads of the bolts; for extra safety you can use some regular glue (fig.
6).
To remove the E-convect from the wall, you open the caps and unscrew the bolts.
Use and Working
Make sure the heater is not damaged.
Insert the plug in the socket
Turn the switch on (I): the light will turn on
To switch the E-convect off, you turn the switch off (O); the light goes out. Remove the plug
from the socket.
… 13 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Eurom E-convect at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Eurom E-convect in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info