510022

Eurom E-convect Manual

11
Zoom out
Zoom in
Previous page
1/20
Next page
English
Technical data
Type EUROM E-CONVECT
Supply voltage 220-240Volt / 50060Hz
Insulation class II, double insulated
Maximum capacity 425 Watt
Suitable for 9 tot 16 m²
Dimensions 3,3 (24,8) x 60 x 60 (63) cm.
Weight 5,3 kg.
General safety instructions
1. Before using the machine, carefully read this entire instruction manual.
2. Before using your new heater, check it, including cord and plug, for any visible damage. Do not use a
damaged heater, but send it back to your dealer for replacement.
3. Do not use the heater until it is been fully installed in accordance with the instructions under the
heading ‘Description, Composition and Installation’.
4. This heater is strictly intended for normal domestic use. Only use it for the additional heating of your
home.
5. This heater in not suitable for use in wet or damp spaces such as bathrooms and laundry rooms. Do
not place the heater in the vicinity of taps, bathtub, shower, pool, fountains or other sources of
moisture. Make sure it cannot fall into water and prevent water from getting into the heater itself. If, at
any time, the heater does fall into water, unplug it immediately! Do not use a heater that has a damp
interior but have it repaired. Never immerse the heater, cord or plug in water and never touch it with
wet hands.
6. The supply voltage and utility frequency, specified on the machine, need to match those of the socket
that is used. The electrical installation needs to be secured with a ground-fault circuit interrupter (max.
30 mAmp). The electrical socket that you are using must be to hand at all times in order to be able to
remove the plug from the socket in the event of an emergency
7. Fully extend the cord before plugging in the heater. Make sure it does not come into contact with any
part of the heater and prevent it from heating up any other way. Do not run the cord underneath
carpeting; do not cover it with mats, carpet strips or similar and make sure it is not placed in any
passageways. Make sure the cord cannot be stepped on and that no furniture is placed on top of it.
Do not lead the cord around sharp corners and do not roll it up too tightly after use!
8. If possible, do not use an extension cord, as this poses the risk of overheating and fire. If the use of an
extension cord is unavoidable, then make sure it is an undamaged, approved extension cord with a
minimum diameter of 3 x 1.5 mm² and a minimum permissible power of 500 Watt. To prevent
overheating, always fully extend the cord!
9. During use the plug can feel a little warm, that's normal. Is it really warm, then there is probably
something wrong with the socket. Contact your electrician.
10. To prevent the circuit being overloaded and fuses blowing, make sure no other appliances are
connected to the same socket or wired to the same electrical circuit as the heater.
11. Do not use the heater outdoors and do not use it in spaces, smaller than 4,5 m².
12. A heater contains hot and/or glowing and sparking components. Do not, therefore, use it in areas
where fuels, paint, flammable liquids and/or gasses etc. are stored.
13. Do not place the heater near, under, or directly opposite a socket and do not place it near an open fire
or other heat source.
14. Do not use the heater near or directly opposite furniture, animals, curtains, paper, clothes, bedding or
other inflammable objects. Keep them at least 1 metre away from the heater!
15. Never cover a heater! Never use the heater to dry clothes and do not place anything on top of the
heater. Do not place it on soft surfaces such as beds or deep-pile carpets.
16. Make sure that the air around the heater can circulate freely. Do not place the heater too close to
walls or large objects and do not place it under shelves, cupboards or similar. For hanging installation:
don’t block the space between stove and wall.
17. Always switch the heater off, unplug it and leave to cool down before:
- cleaning the heater
- carrying out maintenance on the heater
- touching or moving the heater.
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Eurom E-convect at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Eurom E-convect in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info