783787
18
Zoom out
Zoom in
Previous page
1/161
Next page
32 EN EN 33
Problems Solutions
You cannot schedule
cleanings.
Make sure the main power switch on the bottom of
RoboVac is turned on.
Make sure the scheduled time has been set correctly.
Check if the time zone in the EufyHome app is consistent
with that on your mobile device.
Check if RoboVac’s power is too low to start cleaning.
Cleaning schedules are erased when RoboVac is powered
off or when reset to factory default settings. If RoboVac is
powered on without Internet access, cleaning schedules
will not synchronize and must be reset via the app.
Suction power is weak.
Check if any obstructions are blocking the suction inlet.
Empty the dust collector.
Check if the filter is wet due to water or other liquid on
the floor. Air-dry the filter completely before use.
RoboVac cannot be
charged.
Check if the indicator on the Charging Base lights up. If
not, reconnect the adapter with the Charging Base and
try a new power outlet. If the problem persists, contact
the eufy service center to repair or replace the Charging
Base.
Dust off the charging contact pins with a dry cloth.
Check if you can hear a beep when RoboVac is docked
onto the Charging Base. If not, contact the eufy service
center to repair or replace the Charging Base.
RoboVac cannot return
to the Charging Base.
Remove objects within 3 ft/1 m to the left and right side
and within 6 ft/2 m of the front of the Charging Base.
Check if RoboVac is stuck by any objects.
Clean the charging contact pins.
RoboVac’s movements
or travel path are
abnormal.
Clean the sensors carefully with a dry cloth.
Restart RoboVac by turning the power switch off and on.
Water does not come
out during mopping.
Make sure there is enough water in the water tank.
Make sure the water tank and mopping cloth are properly
installed.
Check if the water outlets are blocked. If yes, replace the
filter elements.
Problems Solutions
Too much water
comes out during
mopping.
Make sure the water tank has been installed properly.
Make sure the filter elements are correctly installed in
place.
RoboVac's cleaning
time becomes shorter
Make sure RoboVac is fully charged (indicated by a solid
blue LED light) before cleaning.
The cleaning time will be affected by the suction mode
and floors/rugs to be cleaned:
On floors: approx. 100 / 80 / 70 / 40 minutes of
cleaning in Quiet / Standard / Turbo / Max suction
mode respectively
On rugs: approx. 80 / 60 / 55 / 30 minutes of
cleaning in Quiet / Standard / Turbo / Max suction
mode respectively
Check if RoboVac has alerted you with any voice prompts
or LED indicators. Refer to the “Voice Alert” section in
this manual.
If your cleaning time is much less than the time
mentioned above, contact eufy customer service for help.
RoboVac cannot
connect to a Wi-Fi
network.
Make sure you entered the Wi-Fi password correctly.
Make sure your RoboVac, router, and mobile phone are
close enough to ensure a strong signal strength.
Make sure your Wi-Fi router supports the 2.4GHz and
802.11b/g/n bands; the 5GHz band is not supported.
You cannot control
RoboVac with Amazon
Alexa.
Check if there are any Internet connection problems.
Check whether you have installed the Amazon Alexa
app onto your smart device and enabled “EufyHome -
RoboVac” Skill in the Amazon Alexa app. For details, refer
to the “Smart Integrations” page in the EufyHome App.
Make sure you have an EufyHome account and have
connected to RoboVac.
Make sure you are using correct Alexa voice-commands.
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Eufy Robovac G20 Hybrid - T2258 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Eufy Robovac G20 Hybrid - T2258 in the language / languages: English, German, Dutch, French, Italian, Turkish, Spanish as an attachment in your email.

The manual is 24.51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info