565941
12
Zoom out
Zoom in
Previous page
1/240
Next page
© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT
Installation/Operation Supplement
511472 (EN)
10
To attach customer-supplied three-phase power cord
(400 Volt WYE):
1. Remove electrical access panel on rear of
machine.
2. Attach power cord wires as shown in Figure 7.
3. Attach strain relief, supplied with machine, to
power cord in accordance with all local codes
and ordinances.
4. Reinstall access panel.
Figure 7
Grounding and Wiring Instructions
The dryer must be connected to an earthed metal,
permanent wiring system; or an equipment-earthing
conductor must be run with the circuit conductors and
connected to the equipment-earthing terminal or lead
on the dryer.
NOTE: Electrical receptacle must be located so
that it is easily accessible with machine in place. If
machine is hard wired, an intermediate shut-off
box with a 3 mm gap is required [335-1 (22.2)].
Gas Dryers
NOTE: This manual is only a supplement. Refer to
installation/operation manual for full instructions.
(230 Volt, 50 Hertz, 2 Wire Plus Earth, 10 Amp
Installation)
The dryer is designed to be operated on a two-wire
plus earth, 230 Volt, 50 Hertz, single-phase supply
circuit fused at amperage found on serial plate.
Figure 8
NOTE: Electrical receptacle must be located so
that it is easily accessible with machine in place.
DRY1931N
L 1 L 2 L 3 N
400 Volt
400 Volt
400 Volt
230 Volt
230 Volt
230 Volt
D210I
1 13 Amp Fuse
To reduce the risk of fire, electric shock,
severe personal injury or death, the
electrical service to a gas dryer must
abide with local electrical codes. The gas
service to a gas dryer must conform with
the local codes and ordinances, or in the
absence of local codes and ordinances,
with the latest edition of the National Fuel
Gas Code ANSI Z223.1.
W238
WARNING
1
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Eudora T11 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Eudora T11 in the language / languages: English, German, Dutch, French, Italian, Swedish, Turkish, Spanish, Norwegian as an attachment in your email.

The manual is 6,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info