517045
42
Zoom out
Zoom in
Previous page
1/62
Next page
GB 12
Stopping or changing a wash cycle
1. Open the door.
2. Press the start/reset button more than three seconds.
The program stops. The indicator light goes out.
3. Press the start/reset button again and select the desired washing
program with the selector button.
4. Close the door.
The indicator light will light up and the washing program starts
immediately.
Attention!
A cycle that has already begun can only be changed in the start-up
phase. After this, the detergent will be sprayed all over the dishes or
the machine may have already pumped out the water. In that instance,
you must refill the detergent compartment (see section on Dishwasher
detergent).
Warning!
It is dangerous to open the door completely when washing, because the hot
water may scald you.
At the end of the wash cycle
Once the wash cycle has completed, an audible signal will sound for
eight seconds.
1. Switch the appliance off using the On/Off button.
2. Open the door.
3. Wait a few minutes before unloading the dishwasher. The dishes
and cutlery will still be very hot immediately following the end of the
cycle. There is a chance that dishes may break as a result of the
heat. Moreover, the dishes dry better when allowed to stand for a
few minutes.
Cycle selection table
Cycles Information Cycle process Time in min.
3 in 1
3-in-1 For normally soiled loads. Use
multifunctional detergent.
Pre-wash (50 °C)
Wash (55 °C)
Rinse
Rinse (65 °C)
Drying
160
OPERATION
42


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Etna EVW8262 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Etna EVW8262 in the language / languages: English, Dutch as an attachment in your email.

The manual is 4,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info