71148

Etna 1424 VT WT Manual

42
Zoom out
Zoom in
Previous page
1/50
Next page
42
HOW TO USE THE COOKER
VENTILATION
All gas cooking appliances produce heat
and moisture in the rooms where they are
installed. Take care to ensure that the ki-
tchen is well ventilated; keep the ventilation
openings unobstructed or install an extractor
hood with fan.
In case of intensive or prolonged use, additio-
nal ventilation may be required; open a win-
dow, or increase the extractor fan power.
IGNITING THE HOB BURNERS
- Press the knob and turn it anti-clockwise
until it reaches the
symbol on the control
panel (maximum fl ame position);
- at the same time, move a burning match
towards the burner head;
- to reduce the fl ame, turn the knob further in
the same direction until its pointer is against
the
symbol (minimum fl ame position).
FOR HOB BURNERS EQUIPPED WITH
SAFETY DEVICE
- Press the knob and turn it anti-clockwise
until it reaches the
symbol on the control
panel (maximum fl ame position);
- move a burning match towards the burner,
keeping the knob pressed right dow for
about 10 seconds;
- then release the knob and check that the
burner remains on. Otherwise, repeat the
operation.
IGNITING THE OVEN BURNER
- Open the oven door;
- press the knob and turn it anti-clockwise to
the maximum fl ame position;
- move a burning match towards the hole in
the centre of the oven bottom and press the
knob right down (see fi g. 7);
- check that the burner has ignited, looking
through the hole in the centre of the bottom,
keeping the knob pressed all the time;
- after about 10 seconds, release the knob
and check that the burner remains on.
Otherwise, repeat the operation.
IGNITING THE GRILL BURNER (GAS
GRILLS)
- Fit the control knob guard as shown in fi g.
10;
- press the oven knob and turn it to the right
until it reaches the stop;
- move a burning match towards the perfo-
rated burner pipe and press the knob right
down (see fi g. 8);
- check that the burner has ignited, keeping
the knob pressed down;
- after about 10 seconds, release the knob
and check that the burner remains on.
Otherwise, repeat the operation.
SAFETY DEVICE
Burners equipped with this device have the
advantage that they are protected if they ac-
cidentally go out. If this occurs, the supply of
gas to the burner concerned is automatically
cut off, preventing the hazards deriving from
a leak of unburnt gas. The gas supply must
be cut off within no more than 60 seconds
for the oven and grill burners or 90 seconds
for the hob burners.
FOR COOKERS WITH ELECTRIC IGNI-
TION
All the above applies, except that the match
is no longer required; a spark is obtained
by pressing the button on the control panel
once or more, or by pressing the knob of the
burner to be ignited.
If electronic ignition is diffi cult with some
types of gas, set the knob on the low (small
fl ame) setting.
- For cookers with electric ignition of the oven
and grill burners, ensure the oven door is
completely open when these burners are
ignited;
- Do not operate the ignition device for more
than 10 seconds when igniting the oven and
grill burners. If the burner has not lit after
these 10 seconds, stop using the device,
leave the door open and wait one minute
For the user
GB
… 42 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Etna 1424 VT WT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Etna 1424 VT WT in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info