621623

Ergofix 77207-1 Manual

26
Zoom out
Zoom in
Previous page
1/44
Next page
24
▪ Make sure of the direction of motor rotation. Turn the motor on, the wedge ram
should rise to the highest position automatically. If the wedge ram is already at
the highest position when the motor starts, grip both control levers and lower
them, the wedge ram should start to move downward.
In case no ram motion is detected after the motor starts, stop the motor
immediately (see chapter 4 point 6).
NEVER ALLOW MOTOR RUNNING AT COUNTER DIRECTION. THIS WILL
DAMAGE THE PUMP AND WILL VOID THE WARRANTY.
▪ While operating under extremely low temperature, keep the log splitter running
without load for 15 minutes to preheat the hydraulic oil.
Before initial operation, check to be sure the two-handed operation is properly
functioning by the following steps:
¾ Lower bothe control levers, splitting wedge shall move downward to approx.
5 cm above the highest table position.
¾ Release either of the levers, splitting wedge shall remain in the original
position.
¾ Release both levers, the wedge shall rise to the highest position
automatically.
To set wedge ram stroke, take the following steps:
¾
Move splitting wedge to desired position. The upper position of the ram
wedge travel should be about 3 - 5 cm over the logs to be split.
¾
Release a control lever or switch off the motor.
¾
Set the correct height by mounting the chain in the desired link of the eye on
the presssquare
¾
Release both control levers or switch on motor,
¾
Check upper position of splitting wedge.
Place log onto splitter. Place the log onto the support table vertically and
standing flat on the support table. Be sure the wedge and support table will
contact the log perpendicular to the ends. Never attempt to split a log at an
angle.
Split the log lengthways to its growth. Do not place a log across the support table
for splitting. It may be dangerous and may seriously damage the machine.
… 26 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ergofix 77207-1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ergofix 77207-1 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info