214749
103
Zoom out
Zoom in
Previous page
1/165
Next page
102
Monitoring and Controlling Projectors via a Network (for the EMP-7900)
User’s Guide
Press the [Num] button on the remote control to enter
numbers.
You may need to enter numbers as part of the settings for an
item. If you press the [Num] button, it will light up and the
remote control buttons shown right can be used as a numeric
keypad.
Press the [Num] button again to cancel the numeric keypad
mode.
The following table shows the setting details for each item.
Once the settings have been made, press the [Menu]
button to close the configuration menu.
DHCP
g
Sets whether DHCP is used or not.
ON: DHCP is used.
OFF: DHCP is not used.
IP Address
g
Settings can be entered when "DHCP" is set to "OFF".
Enter the IP address that has been assigned to the
projector.
Subnet Mask
g
Settings can be entered when "DHCP" is set to "OFF".
Enter the subnet mask that has been assigned to the
projector.
Gateway
g
Address
Settings can be entered when "DHCP" is set to "OFF".
Enter the IP address for the gateway that has been
assigned to the projector.
Remote control
The buttons inside the box will switch
to numeric keypad mode while the
[Num] button is lit.
Numeric buttons
SNMP
g
Enter the IP address to use for notification of SNMP
traps. Two IP addresses can be set as notification
addresses: "Trap IP Address
g 1" and " Trap IP Address
2". If a notification cannot be sent to the IP address that
is set for "Trap IP Address 1", then it is sent to the IP
address that has been set for "Trap IP Address 2".
MAC
Address
g
Shows the MAC address for the projector.
Projector name The projector name is a unique name that is used to
distinguish the projector from other projectors on the
network. Use EMP NetworkManager to change the
projector name. p.104
TIP
Once the projector has been connected to the network, EMP
NetworkManager can be used to change the projector's network
settings. p.104
103


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Epson emp 7950nl at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Epson emp 7950nl in the language / languages: English as an attachment in your email.

The manual is 9,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info