749195
35
Zoom out
Zoom in
Previous page
1/48
Next page
35
IP2288EN
EN
Display Description Selections
available
CA - Setting the maintenance alarm
(factory setting - alarm deactivated: 0.0 00. 00).
You can set the required number of operations (regarding the partial operations counter)
for signalling the maintenance alarm.
When the set number of operations is reached, the alarm message appears on the
display .
Example:
Setting the maintenance alarm after 700 operations (00) (07) (00)
→→ →→
2”
OA - Selecting maintenance alarm display mode
00 - Visualisation on display (alarm message )
01 - Visualisation on flashing light (with the automation idle, 4 flashes are
made and then repeated every hour) and on display (alarm message ).
02 - Visualisation on "open gate" indicator light (with the automation closed,
4 flashes are made and then repeated every hour) and on display (alarm
message ).
ZP - Reset of partial operations counter
2”
For correct functioning, you are advised to reset the partial operations counter:
- after maintenance work;
- after setting the maintenance alarm interval.
15.7.1 Additional CC level parameters that can be configured
(available with enabled)
CC
15.8 Second level menu - EM (Energy Management)
Display Description Selections
available
PV - Solar panel power supply (panels not supplied)
ON - Enabled
OF - Disabled
ES - Energy-saving (disconnection of accessories connected to terminals 0-1
when the automation is in standby)
ON - Enabled (the red point on the right of the display flashes every 5 s. Output
+LP- is managed only for courtesy light).
OF - Disabled
Power supply disconnection mode is activated after 15 s with the gate closed,
or when the gate is idle and automatic closure is not enabled.
The automation resumes its normal operation when a command is received on
the radio board (6ZENRS-ZENPRS) or following a contact 30-5, 30-20.
WARNING: if you use accessories that need to remain powered even with
Energy Saving is enabled (e.g. LAN4 or GOPAV), set the jumper JR5 relating to
the slot used on power supply 0-30.
EM - Energy management
35


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Entrematic Ditec ION6 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Entrematic Ditec ION6 in the language / languages: English as an attachment in your email.

The manual is 1,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info