601366

Enduro EM305 Manual

40
Zoom out
Zoom in
Previous page
1/60
Next page
ENDURO
®
EM305 34
Ref: EM305-UM-TKI-0115-Rev.A.
Traction indicator label:
The yellow-green-red traction indicator label (Fig. 11A), on the side of each motor unit indicates if the roller is
depressing the tyre sufficiently to provide adequate traction.
If the pointer is in the yellow area – Rollers are not touching or depressing the tyre sufficiently.
If the pointer is in the green area – Rollers should be connecting correctly to the tyre (margin of 15mm).
If the pointer is in the red area – Rollers are connected to the tyre but in an extreme position. It could be
that the tyre of the caravan has insufficient air pressure or the drive unit has been knocked out of position
and a visit to a workshop is required to reposition the assembly.
Disconnect the motor powered rollers in case of emergency:
In the case that the caravan battery is discharged to far to automatically take of the motor powered rollers of
the tyre, or there is a defect, you can also do this manually. See figures 9 & 9.1.
Take the plastic cap (Fig. 9B) at the rear side of the housing of the motor for the automatic engaging system.
If necessary use a screwdriver. Place the emergency key (6) on the emergency socket in the motor unit (Fig.
9A & 9.1C) and turn it until the motor unit including motor powered rollers are in the beginning position. Repeat
this also on the motor unit on the other side.
Put the plastic caps back on the motor housing.
As soon as the battery is charged again, or the problem is solved, the motor powered rollers automatically work
again.
OPERATION - REMOTE CONTROL HANDSET
The remote control handset (5) is powered by one PP3 9Volt battery, and is activated by moving the slide
switch to “On”-I (Fig. 5A). Once activated the green LED (Fig. 5H) will illuminate and the directional controls
can now be used.
Fig. 5
A. Slide switch (“Off” –O and “On”-I)
B. Caravan forwards (both wheels rotate in forwards direction)
C. Caravan reverse (both wheels rotate in reverse direction)
D. Caravan left forwards (right wheel rotates in forwards direction)
E. Caravan right forwards (left wheel rotates in forwards direction)
F. Caravan left reverse (right wheel rotates in reverse direction)
G. Caravan right reverse (left wheel rotates in reverse direction)
H. Green LED: reflects status of the remote control and caravan manoeuvring system
I. Two handed service for automatic engaging of the motor powered rollers to the tyre
J. Two handed service for automatic disengaging of the motor powered rollers from the tyre
K. Blue LED: reflects status of the automatic engaging system
L. Red overload LED: Amp overload protection is activated. Wait about 60 seconds and try again
M. Blue 9V battery LED: The internal 9V battery of handset is near empty and needs to be replaced
N. Blue battery voltage LED: Caravan battery voltage too low or too high
When you drive straight forwards or reverse (press button B or C), it is also possible to adjust the direction by
additional pressing button D or E (when driving forwards) or button F or G (when driving reverse).
In addition, the ‘right forward’ (E) and ‘left reverse’ (F) buttons or ‘left forward’ (D) and ‘right reverse’ (G)
buttons may be pressed at the same time to turn the caravan around on its own axis without moving forward or
backward (this function just can work under the “single-axle function”).
When you switch within 2 seconds from forward driving to reverse driving (and the other way around), a small
delay of 1 second will appear to protect the electronics and the motors.
The slide switch (Fig. 5A) also acts as an “Emergency stop”.
The automatic engaging system:
To activate the automatic engaging system of the motor powered rollers on the tyre, press the two buttons for
engaging (Fig. 5I) or disengaging (Fig. 5J) for at least three seconds. The blue LED (Fig. 5K) will blink fast
during these three seconds and every second there will be a beep. This warns you that the system will be
activated!
Engaging:
After these three seconds the motor powered rollers will be pressed against the tyre, and the blue
LED will illuminate constant. Now you can release the two buttons. When the motor powered rollers are pressed
on the tyre strongly enough you hear a short beep, the blue LED will switch off and the system is ready to use.
Disengaging:
after these three seconds the motor powered rollers will be released from the tyre, and the blue
LED will illuminate constant. Now you can release the two buttons. When the motor powered rollers are
completely disengaged you hear a short beep, the blue LED will switch off and is the system ready for transport.
… 40 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Enduro EM305 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Enduro EM305 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 5,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info