601366

Enduro EM305 Manual

38
Zoom out
Zoom in
Previous page
1/60
Next page
ENDURO
®
EM305 32
Ref: EM305-UM-TKI-0115-Rev.A.
(out of reach of children or other unauthorised people).
Installation of the caravan manoeuvring system is now complete.
INSTALLATION – TWIN AXLE
This manual describes the general installation and use of the manoeuvring system for single axle caravans.
When you use the manoeuvring system for a twin axle caravan, please check the following:
Permissible overall weight twin axle (2 motors) 2000kg (1750kg on 18% gradient)
Permissible overall weight twin axle (4 motors) 3000kg (2350kg on 18% gradient)
2 motors:
The procedure for installing a 2 motors manoeuvring system on a twin axle caravan is the same as for a single
axle caravan. The electronic control unit (4) only must be prepared for twin axle use:
Turn off the battery power isolation switch and move the single/twin axle function switch (Fig 3S/T) on the
control unit to the twin axle position (Fig. 3T), so that the manoeuvring system can be used for a twin axle
caravan. In the twin axle function when making curves, all wheels will drive but at a different speed.
4 motors:
The procedure for installing a 4 motors manoeuvring system on a twin axle caravan is similar than for a single
axle caravan but then with two sets of manoeuvring system.
Follow the procedure INSTALLATION - MECHANICAL COMPONENTS twice: one time for the manoeuvring
set mounted in front of the twin axle and one time for the manoeuvring set mounted behind the twin axle.
Follow the procedure INSTALLATION - ELECTRICAL/ELECTRONIC COMPONENTS twice: one time for the
manoeuvring set mounted in front of the twin axle and one time for the manoeuvring set mounted behind the
twin axle.
Note: When installing the four motors it will be necessary to use one
higher capacity battery to supply both
sets of manoeuvring system (including two electronic control units and two of battery power isolation switches).
Do not use two separate batteries for a 4 motors manoeuvring system on a twin axle caravan.
Now both electronic control units (4) must be prepared for twin axle use:
Turn off the battery power isolation switch and move the single/twin axle function switch (Fig 3S/T) on the
control unit to the twin axle position (Fig. 3T), so that the manoeuvring system can be used for a twin axle
caravan. In the twin axle function when making curves, all wheels will drive but at a different speed.
Finally both electronic control units (4) must be prepared for the use of only one remote handset (32). The
remote handset need to be synchronised with both electronic control units using the following procedure:
Check the installation in accordance with the installation instructions and ensure that the drive rollers are
not applied. Check that the battery is properly connected, check the condition of the battery and that a
voltage of 12V is present at the control unit.
Please ensure that both battery isolation switches are on.
Activate the remote control handset by sliding the slide switch to “On”-I (Fig. 5A). The green LED on the
remote control handset (Fig. 5H) starts to flash slowly.
Press the reset button (Fig. 3A) on the control unit. All three LED’s on the control unit (Fig. 3B, 3C & 3D)
will flash slowly.
Press both forwards (Fig. 5B) and reverse (Fig. 5C) button on the remote control handset for about 3
seconds. Then the handset buzzer will give a short beep to confirm that the synchronisation is complete.
After successful synchronisation, the green LED on the control unit (Fig. 3B) and on the remote control
handset (Fig. 5H) will illuminate continuously.
Repeat this procedure with the second electronic control unit.
Turn the remote handset “Off” and then “On” again so both control units will be activated.
The installation of the caravan manoeuvring system for twin axle use is now complete. For details of the
operation, use and all the LED and button functions, please refer to the standard chapters of this manual.
OPERATION - SAFETY GUIDELINES
Practice operating the manoeuvring system in an open area before using for the first time. This is to fully
familiarise yourself with the handset / manoeuvring system operation.
Before use, always check the caravan manoeuvring system for any damage.
When towing or moving the caravan please be aware, at all times, that ground clearance is reduced
when the manoeuvring system has been fitted.
Always ensure that children and pets are kept well out of the way during operation.
… 38 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Enduro EM305 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Enduro EM305 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 5,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info