722072

Enduro AS101 Manual

44
Zoom out
Zoom in
Previous page
1/48
Next page
ENDURO
®
autoSteady 37
Ref: AS101-UM-TKI-0114-Rev. A
Press for at least three seconds the “AUTO DOWN” button (Fig. 10J) with two hands at the same time. The blue
LED (Fig. 10K) will blink during these three seconds and every second there will be a beep. This is warning you
that the system will be activated.
After these three seconds the auto function will start and the corner steadies will automatically act. The blue
LED (Fig. 10K) on the remote control will illuminate continuously. Now you can release the “AUTO DOWN”
button.
The corner steady will act as following:
• first the two back corner steadies (Fig. 8B and Fig. 8D) lower
• then the two front corner steadies (Fig. 8A and Fig. 8C) lower
• than the back corner steadies (Fig. 8B and Fig. 8D) lower again
• finally the two front corner steadies (Fig. 8A and Fig. 8C) lower again
After activating the “AUTO DOWN” function, before the corner steadies lower, there maybe have a delay about
3 seconds. If one or more corner steadies are not at the complete draw back position, these corner steady will
be draw back for about 3 seconds first.
When the AUTO function process is finished, there will be a beep.
Since the autoSteady system is not equipped with an automatic levelling system, it can happen that the
caravan is not completely levelled out anymore. This can be caused by the use of a flexible jockey-wheel, or a
different spreading of the weight of your caravan or a different friction in the corner steady.
If needed, you can adjust every corner steady individually and slightly level out your caravan again.
The single corner steady function is used to adjust the height of single corner steady a little.
Do not try to jack the caravan by this function, this could completely damage your caravan
chassis or floor.
Different caravan chassis or floors have different situation for jack-up force. Using the
single corner steady function button have the possibility to completely damage your caravan
chassis or floor. The stop setup on the single corner steady function is used to protect the
motor and control unit, it cannot protect your caravan chassis or floor all the time (this due
to the various caravan models).
In general we recommend to use only the “AUTO” function.
After operation, deactivate the autoSteady system by moving the slide switch (Fig. 10A) to “Off”-O on the
remote control. The LED (Fig. 10H) on the remote control will turn off. Store the remote control in a safe place
(out of reach of children or other unauthorized people).
Turn off the battery power isolation switch (24).
When you want to draw back all the corner steady, you act as following:
Before starting the operation of the system, the handbrake must be secured and the jockey
wheel must be tightly fixed and tough the ground.
Turn on the battery power isolation switch (24).
Activate the autoSteady system by moving the slide switch to “On”-I on the remote control (Fig. 10A). The
green LED (Fig. 10H) will illuminate and you will hear a short beep. The system is ready for use.
First check if the slide switch (Fig. 10O) is in “autoSteady” mode (Fig. 10Q).
Press for at least three seconds the “AUTO UP” button (Fig. 10I) with two hands at the same time. The blue LED
(Fig. 10K) will blink during these three seconds and every second there will be a beep. This is warning you that
the system will be activated.
After these three seconds the auto function will start and the corner steadies will automatically act. The blue
LED (Fig. 10K) on the remote control will illuminate continuously. Now you can release the “AUTO UP” button.
The corner steady will act as following:
• first the two front corner steadies (Fig. 8A and Fig. 8C) draw back completely
• than the two back corner steadies (Fig. 8B and Fig. 8D) draw back completely
When the AUTO function process is finished, there will be a beep.
… 44 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Enduro AS101 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Enduro AS101 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 5,72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info