708667

Elro AP5500 - Pro Alarm System Manual

45
Zoom out
Zoom in
Previous page
1/49
Next page
40
LOW BATTERY INDICATION
Note: Before removing the battery cover on any device
to replace the battery ensure that the system is put into
Test mode to avoid initiating a Full Alarm condition.
The low battery indication for each system component
is as follows:
Control Panel
During a period of mains supply interruption the Control
Panel will be powered by the rechargeable backup
batteries. Under normal battery conditions the Power
LED on the panel will flash at 1s intervals. However,
under low battery conditions the Power LED will flash
at 3s intervals.
Remote Control
When the Remote Control is operated under low
battery conditions the transmit LED will continue to
flash after the button has been released.
Under normal battery conditions the LED will
extinguish when the button is released.
PIR Detectors
Under low battery conditions the LED behind the
detector lens will flash when movement is detected to
indicate that the battery needs to be replaced.
Under normal battery conditions the LED does not
illuminate unless the PIR detector is in Walk Test
mode.
Magnetic Contact Detectors
Under low battery conditions, when the Detector is
activated the transmit LED will be illuminated for
approximately 1s as the door/window is opened.
Under normal battery conditions the LED will not
illuminate as the Detector is operated, (unless the
Detector is in Test Mode with the battery cover
removed).
MAINTENANCE
Your Alarm System requires very little maintenance.
However, a few simple tasks will ensure its continued
reliability and operation.
CONTROL PANEL
The rechargeable batteries have a typical life of 3-4
years and need no maintenance during this period,
provided they are kept charged. The batteries will be
damaged if they are stored in a discharged state for
long periods.
DETECTORS AND REMOTE CONTROL
The Detectors require very little maintenance. The
batteries should be replaced once a year or when a low
battery status is indicated.
IMPORTANT: Should you, for any reason, have to
completely power-down the system (e.g. to move the
system to a new premises) first put the system into Test
mode before removing the Control Panel cover and
disconnecting the power supply and backup batteries.
BATTERIES
Before removing the battery cover on any device to
replace the battery, ensure that the system is put into
Test mode to avoid initiating an Alarm.
The specifications for replacement batteries are as
follows:
Remote Controls
1 x 3V CR2032 Lithium Cells
(or equivalent)
Magnetic Contact
Detectors
2 x 3V CR2032 Lithium Cells
(or equivalent)
PIR Detectors
1 x 9V PP3 Alkaline
Note: Where applicable only fit PP3 Alkaline type
batteries. Rechargeable batteries should NOT be
fitted.
At the end of their useful life the batteries should be
disposed of via a suitable Recycling Centre. Do not
dispose of with your normal household waste. DO
NOT BURN.
The Rechargeable batteries contain Sulphuric Acid –
DO NOT ATTEMPT TO OPEN THE CASING.
43
… 45 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elro AP5500 - Pro Alarm System at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elro AP5500 - Pro Alarm System in the language / languages: English as an attachment in your email.

The manual is 3,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Elro AP5500 - Pro Alarm System

Elro AP5500 - Pro Alarm System Quick start guide - English - 8 pages

Elro AP5500 - Pro Alarm System Quick start guide - German - 10 pages

Elro AP5500 - Pro Alarm System Quick start guide - Dutch - 8 pages

Elro AP5500 - Pro Alarm System User Manual - Dutch - 42 pages

Elro AP5500 - Pro Alarm System Quick start guide - French - 9 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info