614466
46
Zoom out
Zoom in
Previous page
1/90
Next page
42
Stop just before the zipper foot reaches the slider on
the zipper tape. Lower the needle slightly into the
fabric. Raise the zipper foot and open the zipper.
Lower the foot and stitch the remainder of the seam.
Close the zipper and spread the fabric flat with the
right side facing up. Set stitch length to 4 and baste
through the opened seam allowance and zipper
tape.
Reset stitch length to 2.5.
Move the zipper foot to the left side pin. Guide the
edge of foot along the zipper teeth and stitch through
the garment and zipper tape. Stop about 5 cm (2”)
from the top of the zipper.
Slightly lower the needle into the fabric. Raise the
foot, remove the seamline basting stitches and open
the zipper. Lower the foot and stitch the remainder of
the seam, making sure the fold is even. Remove
remaining basting stitches.
46


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elna eXplore 240 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elna eXplore 240 in the language / languages: English, German, French as an attachment in your email.

The manual is 5,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info