703983
106
Zoom out
Zoom in
Previous page
1/117
Next page
106
Replacing the Movable Cutting Blade
A spare movable cutting blade is located in
the accessory box. Replace the blade when it
becomes dull or nicked.
1. Unplug the machine.
2. Open both front and side covers.
3. Set the movable cutting blade (a) in its
engaged position and lock the movable
cutting blade. (See page 92.) Remove the
movable cutting blade by loosening the
bolt (b) with the wrench (c) found in the
accessory box.
4. Brush the fixed cutting blade and the
surrounding area to clean out any
accumulation of lint, etc.
Lower the movable cutting blade to its
lowest position by turning the flywheel
towards you. At this position, put a new
blade in place, making sure that the edge
of the blade is approximately 0.5 to 1.0
mm below the surface of the fixed cutting
blade (d). Tighten the bolt (b) firmly.
Unlock the movable cutting blade.
NOTE: The fixed cutting blade is made of a
special hard alloy and will not normally have
to be replaced.
Replacing the Light Bulb
1. Unplug the machine.
2. Raise the presser foot and swing open
the lamp cover.
3. Pull the bulb downwards and out.
4. Push the new 15 volt 5 watt bulb fully into
the socket. Close the lamp cover.
106


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elna 845 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elna 845 in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 11,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Elna 845

Elna 845 Additional guide - English, German, French, Spanish - 9 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info