668433

Elma 6400 LCR Meter Manual

39
Zoom out
Zoom in
Previous page
1/48
Next page
Elma 6400
39
→range setting(use / )→ →reference value setting (use / /
/ )→ →tolerance setting(use / )→ sorting mode
The tolerance range setting selection: +0.25%→+0.5%→+1% → +2%→ +5%→
+10%→ +20%→ +80%-20%. The default tolerance is +1%.
In the sorting mode,the primary display to show PASS or FAIL status depends on
whether the impedance measured exceeds tolerance range.The current
measurement result will be shown on the secondary display. Press the button
to exit this mode.
WARNING: If the component to be measured is a capacitor, be sure that the
capacitor is fully discharged BEFORE inserting it into the input sockets or
terminals. For large capacitors, it may take longer periods of time for a full
discharge. Inserting a charged or partially charged capacitor into the meter’s input
sockets or terminals may produce an electric hazard and may also damage the
instrument, making it unusable.
• Test Frequency Select
When the button is pressed, the test frequency will be changed sequentially.
There are five different test frequencies (100Hz/120Hz/1kHz/10kHz/100kHz) can
be selected. The test frequency can affect the accuracy of the results depending
on what frequency is selected and what type and value of a component is being
measured or tested. For details on selecting the optimal test frequency for
measurement, refer to the " SUPPLEMENTAL INFORMATION " section.
7. Specifications
Notes:
• Measurement performed at the test socket.
• Measurements performed after correct open and short calibration.
• DUT and test leads must be properly shielded to guard if necessary.
• Q value is the reciprocal of DF.
• Accuracies based within 10% to 100% of full scale of range;
values outside of range should be used as reference only.
• — means parallel or series measurement mode.
… 39 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elma 6400 LCR Meter at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elma 6400 LCR Meter in the language / languages: English, Danish, Swedish, Norwegian as an attachment in your email.

The manual is 0,81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info