741425

Elkron HPA800 Manual

31
Zoom out
Zoom in
Previous page
1/52
Next page
31/52 HPA800
There are no time constraints for the diagnostic phase: the signals on the LEDs and/or the horn remain active
for 10 minutes from the last variation, are then deactivated and remain in this condition until any input changes
status.
WARNING! Only during the diagnostic phase is it possible to change the configuration by means of dip-
switches.
3.2 PRE-ACTIVATION TIME
When all inputs are closed (alarm input, internal microswitch and anti-foam protection), the siren switches to pre-
activation phase. During this 30-second phase, the siren LEDs flash and the horn emits tones. As the 30-second
period approaches, the LEDs will flash faster for 3 seconds and the horn will emit a long tone indicating that the
siren is in operating condition.
WARNING! The siren only becomes operational if the internal tamper contacts (and anti-foam protection,
if present) are at rest, if there are no abnormalities with respect to the set selections and if the alarm input
ALL is at rest. If the ALL input is activated (or unbalanced), the siren sounds and the high-intensity alarm
flashes after the end of the pre-activation time.
The pre-activation time can be interrupted at any time by simply opening the siren cover or unbalancing
the alarm input. The siren will then return to diagnostic mode (see previous paragraph).
3.3 SYSTEM STATUS VARIATION SIGNALLING
The HPA800 siren displays the switching on and off of the system by means of the four central LEDs. It is also
possible to enable the on/off acoustic signal via the DIP B3.
If you do not want the siren to display the system variation on and off, simply do not connect terminal
TC to the alarm control panel.
To enable the system on/off tone, the DIP B3 must be set to OFF.
If the ON/OFF signals are enabled and the system is switched off or on during an alarm cycle, the on
(OFF>ON) and off (ON>OFF) notifications are presented at the end of the alarm cycle. If the switch-on
(OFF>ON) coincides with the activation of the ALL input, this will not be notified.
4 central LEDs
(high brightness)
Horn
(low volume)
System status variation
3 fast blinks
3 short tones
system on
(OFF>ON)
1 long flash
1 long tone
system off
(ON>OFF)
… 31 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elkron HPA800 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elkron HPA800 in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 3,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info