741406
32
Zoom out
Zoom in
Previous page
1/36
Next page
32
ELR60RT 2PH/60
12. ALIGNING THE BARRIERS
For correct alignment, once the barriers are installed, point the optics units of the transmitters and those of the
receivers towards each other. Adjust the lens-holder horizontally by moving it manually after loosening the release
screw on the pivot, and vertically via the front screw to the left of the lens.
Note: Tighten the pivot release screw after making the adjustment
CALIBRATION USING THE SMA SYSTEM
The calibration can be improved by using the supplied filter:
1) Fold the device along the provided creases
2) Place the filter in front of the TX optics, positioning the two hooks on the optics fork pins, to fine-tune the
search for the alignment signal in the case of critical conditions.
It is sufficient to use the filter on the TX only, with no need to repeat the operation on the RX.
Vertical positioning
Horizontal positioning
PIVOT RELEASE SCREW
32


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elkron ELR60RT 2PH-60 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elkron ELR60RT 2PH-60 in the language / languages: English, Italian as an attachment in your email.

The manual is 2,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info