741406
31
Zoom out
Zoom in
Previous page
1/36
Next page
ELR60RT 2PH/60 31
11. WALK TEST AND INSTALLATION
Before securing the RX barrier, perform a Walk test of the transmitter radio range.
Set the control unit to “Walk Test” mode: keep the RX barrier in the desired position and press the Test
button to confirm that the position in question is within the communication range of the control unit;
Once you have verified that the transmitter is operating in the desired position, you can proceed to install
the RX and TX barriers.
Fix the plate to the wall (or to a pole, using the “U”
bracket for 4-4.5cm poles);
Position the device on the plate;
Fix the device to the rear plate using the hole located
under the optics and proceed with the alignment;
After calibration and verification of correct operation
(see following section), replace the cover and secure it
with the closing screw located on the lower part of the
device.
31


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elkron ELR60RT 2PH-60 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elkron ELR60RT 2PH-60 in the language / languages: English, Italian as an attachment in your email.

The manual is 2,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info