782410
41
Zoom out
Zoom in
Previous page
1/127
Next page
38
EN
NAME AND LIST OF COMPONENTS
Your Drivo electronic trainer is made of the following components:
N°1 Drivo body (Rif. A)
N°2 Freehub body spacer (Rif. B)
N°1 Chainstay adapter (Rif. C)
N°1 Power pack (Rif. D)
N°1 Chainstay L right spacer=142 mm (5,6 inches) (Rif. E)
N°1 Chainstay L left spacer=142 mm (5,6 inch) (Rif. F)
N°1 Chainstay L left adapter=130-135 mm (5,1-5.3 inch) (Rif. G)
N°2 Feets (Rif. H)
N°1 Quick release (Rif. I)
CD-ROM
DVD ROM
ASSEMBLING THE DRIVO
- Disassemble the Drivo body (Rif. A)
- Place the Drivo body (Rif. A) vertically as indicated (Pic.1)
and hold it in place with the upper handle
- Rotate the foot tube 90° and place it in the proper bra-
cket welded to the leg (Pic. 1 and Pic. 2).
- Tighten the safety knob (Pic. 3).
- Spread the leg until you can hear the safety lever click
(Pic.4 and Pic. 5).
- (Pic. 6) shows the installation of feet (Rif. H) on the Drivo
foot tube (Rif.A).
INSTALLING THE SPROCKET CASSETTE ON
THE DRIVO FOR M5 L=130 mm and L=135
mm CHAINSTAYS
- Assemble the sprocket cassette on the freehub by ali-
gning the groove profiles.
- In order to use a Shimano® / SRAM® 9/10 cassette, or
others that employ the Shimano® standard, you need to
place the spacer (Rif. B) on the freehub before inserting
the sprocket cassette (Pic. 7).
- If are installing a 9/10-speed cassette by Shimano® /
SRAM® or by other manufacturers that use the Shimano®
Standard, place the spacers (Rif. B) onto the freehub body
NOTE
- Elite cannot be held responsible for any malfunction in-
volving third party software / app / device.
- The two communication protocols are mutually exclu-
sive, so Drivo sends data either via ANT+™ or Bluetooth
Smart, never with both at the same time; when a protocol
connects, Drivo stops using the other one.
- ANT+™ and Bluetooth Smart protocols are mutually
exclusive and cannot be used simultaneously; when a con-
nection to a protocol is successful, Drivo stops exchanging
data with the other protocol.
- The presence of high-voltage electric lines, traffic lights,
electric railway lines, bus or tram electric lines, television
sets, automobiles, cycle computers, gym equipment and
mobile phones inside the operating range of the console,
etc., can be the cause of interference. Therefore the use
of other wireless receivers may alter or completely inhibit
operation of the Drivo due to such interference.
Do not expose the Drivo to direct sunlight for long periods
when they are not in use.
DISCLAIMER
Elite S.r.l. is not liable for any temporary or permanent da-
mage to the physical integrity of the user, whether direct or
indirect, resulting from the use of the trainer.
ATTENTION!
Drivo is equipped with a freehub body compatible with
9/10/11-speed cassettes by Shimano®/ SRAM® or by
other manufacturers that use the Shimano® Standard.
An accessory freehub body compatible with Campagnolo®
9/10/11 speed cassettes is available to replace the ori-
ginal Shimano compatible body provided on Drivo; body
replacement instructions can be found on page 40.
Drivo is compatible with 130 or 135 mm hubs and 5mm
diameter quick-release.
If you are unsure about the type of derailleur on your
bicycle, refer to the bicycle documentation or contact your
dealer to ensure compatibility with Drivo.
41


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elite Drivo at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elite Drivo in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 4.96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info