649836
27
Zoom out
Zoom in
Previous page
1/136
Next page
27
Operation
Use the high suction speed in cases of concentrated kitchen
vapours. It is recommended that the cooker hood suction is
switched on for 5 minutes prior to cooking and to leave in
operation during cooking and for another 15 minutes
approximately after terminating cooking.
Note: if the hood does not work, make sure that it is ON by
using the ON/OFF button.
The button is inside the hood and can be reached by
removing the grease filter.
Fig. 19
Using the remote control
The remote control is able to control all the functions of the
hood:
Select the suction speed (power)
Light ON/OFF
Not implemented
Not implemented
Selecting the suction speed (power):
Press the "" key or the "" key until you see the symbol
relating to the “Select the suction speed (power)” function.
Press the “+” key or the “-” key or the "" key respectively to
increase or diminish or switch off (stand-by) the speed
(suction power).
Light ON/OFF:
Press the "" or "" button, until the LED corresponding to
the "Light ON/OFF" symbol appears on the remote control.
Press the “+” or “-” button to put on or off the lights.
Press the "" to change the status of the lights, from off (all
lights) to on (all lights) and vice-versa.
Configuration of the remote control
To enable the remote control, proceed as follows:
Press the "" or "" button until you can see on the remote
control the symbol "
" related to the function “Reset and
configuration of the filter saturation signalling” and press
continuously on the central button "" for at least 5 seconds.
An audible signal indicates the successful configuration.
Maintenance of the remote control
Cleaning the remote control:
Clean the remote control with a damp cloth and a neutral
solution of detergent without abrasive substances.
Changing the battery:
Open the battery casing using a small screwdriver with a
flat point.
Change the finished battery with a new one of 12 V type
MN21/23
In inserting the new battery respect the polarity indicated
on the battery casing!
Close the battery casing up again.
Disposal of the batteries
Ultimate disposal of the batteries should be handled according
to all national laws and regulations. Do not place used
batteries in your regular waste.
Ultimate disposal of the batteries must be done safely.
Contact your local waste management officials for other
information regarding the environmentally sound collection,
recycling, and disposal of the batteries.
Maintenance
ATTENTION! Before performing any maintenance operation,
isolate the hood from the electrical supply by switching off at
the connector and removing the connector fuse.
Or if the appliance has been connected through a plug and
socket, then the plug must be removed from the socket.
Cleaning
The cooker hood should be cleaned regularly (at least with the
same frequency with which you carry out maintenance of the
fat filters) internally and externally. Clean using the cloth
dampened with neutral liquid detergent. Do not use abrasive
products. DO NOT USE ALCOHOL!
WARNING: Failure to carry out the basic cleaning
recommendations of the cooker hood and replacement of the
filters may cause fire risks.
Therefore, we recommend observing these instructions.
The manufacturer declines all responsibility for any damage to
the motor or any fire damage linked to inappropriate
maintenance or failure to observe the above safety
recommendations.
The hood should be cleaned regularly (at least with the same
frequency with which you perform the maintenance of the
grease filters) internally and externally.
The chimney and the body of the hood are produced in
CRISTALPLANT
®
.
Note: For more details on the material CRISTALPLANT
®
and
the Manufacturer, visit www.cristalplant.it
Maintenance of CRISTALPLANT
®
DAILY CARE
CRISTALPLANT
®
requires an easy and quick daily care.
It is enough to clea CRISTALPLANT
®
using soap and
water or common detergents to remove most of the dirt
and stains that may be deposited on the surface. It is
particularly recommended to rinse the surface well and to
use gel or abrasive detergents with abrasive sponges like
“Scotch Brite©” as in attached sample; doing that way,
the original matt finish, distinguishing feature of
CRISTALPLANT
®
, will keep untouched.
HOW TO PREVENT FROM DAMAGES
The surface is generally strongly resistant against stains
and spots; nonetheless aggressive chemical products,
such as acetone, trichloroethylene, strong acids or bases
are not recommended. After long contact periods, several
substances like ink, cosmetics and dyes, may leave
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elica Ye at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elica Ye in the language / languages: All languages as an attachment in your email.

The manual is 3,01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info