629290
27
Zoom out
Zoom in
Previous page
1/32
Next page
-27-
The second utility, TX Test enables you to identify transmitters.
In TX Test mode, each time a transmission is received, a chime is sounded and the
activated transmitter is displayed.
To initiate TX Test mode:
1. From the Service menu, select Transmitters, TX Test [7072].
2. Activate a transmitter; the transmitter’s details are displayed.
3. When you have finished, press X to exit TX Test mode.
Audio Volume
To adjust the sensitivity of the microphone and the volume of the speaker:
1. Establish a two-way audio connection.
2. From the Service menu, select Audio Volume [708].
3. Adjust the setting according to the following table.
Press To
1 Increase microphone sensitivity
4 Reduce microphone sensitivity
3 Increase speaker volume
6 Reduce speaker volume
4. Press √; the new settings are stored in the memory.
GSM Signal Strength
You can measure the GSM signal strength using the system’s RSSI (Received Signal
Strength Indication) meter.
To view the GSM signal strength reading:
From the Service menu, select
GSM Signal [709]; the signal
strength of the cellular network
is displayed.
Display Version
To display the system’s software and hardware versions:
From the Service menu, select Version [710]; the software (SW) and hardware
(HW) versions are displayed.
Global Chime
Each sensor can be programmed by your engineer to cause the system to chime when
activated. This feature is active only when the system is unset. For example, the system
can be programmed to sound a chime each time the front door is opened or closed. The
Global Chime option, enables you to turn this feature on and off.
To enable or disable Global Chime:
1. From the Service menu, select Global Chime [712].
2. Select either Enable or Disable.
3. Press when the desired setting is displayed.
Global Chime can also be accessed via a convenient shortcut without needing to enter a
valid user code. To access the Global Chime option from Standby mode, press then .
This reading Means
8 to 9 Reception is good
5 to 7 Reception is acceptable
Less than 5 Reception is unacceptable
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Electronics Line Prime at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Electronics Line Prime in the language / languages: English as an attachment in your email.

The manual is 0,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info