573742
13
Zoom out
Zoom in
Previous page
1/100
Next page
13ENGLISH
6. OPERATING INSTRUCTIONS
NOTE
The following instructions represent the
Control Panel, the same instructions can
be used for the Remote Control.
COOLING MODE:
In this mode the exhaust adaptor hose
MUST be used.
1. Press the MODE button until the “Cool”
indicator lights.
2. Press the “
“ Temp buttons for
desired setting.
3. Press the FAN button for desired fan
speed.
HEATING MODE: (on some models)
In this mode the exhaust adaptor hose
MUST be used.
1. Press the MODE button until the “Heat”
indicator lights.
2. Press the “
“ Temp buttons for the
desired heat setting.
3. Press the FAN button for desired fan
speed.
4. Connected drain hose. See drainage
section.
DRY MODE:
In this mode you do not need to use
the exhaust adaptor hose, BUT the
water collected must be discharged.
See Drainage Section.
1. Press the MODE button until the “Dry”
indicator lights.
2. The fan will run at low speed and the
display will show the room temperature.
3. Keep doors & windows closed for best
effect.
AUTO MODE:
Always have the exhaust hose
attached in this mode.
When you set the air conditioner in AUTO
mode, it will automatically select cooling,
heating(inapplicable for cooling only
models), or fan only operation depending
on what temperature you have selected
and the room temperature. The air
conditioner will control room temperature
automatically round the temperature point
set by you.
Under AUTO mode, you can not select the
fan speed.
FAN MODE:
In this mode there is no need to use
the exhaust hose or drainage hose.
However, if you require stale or
smokey air to be removed from the
room, hook up the duct accessories
as described in the “EXHAUSTING
HOT AIR” section.
1. Press the MODE button until the “Fan”
indicator lights.
2. Press the FAN button to choose the
desired fan speed.
3. The fan will run at the selected speed
and the display will show the room
temperature.
TIMER OPERATION:
You can set both delay stop and delay
start while unit is in ON position or OFF
position. When unit is in ON position,
rst press TIMER button to go to delay
stop setting, then “timer off” light will
illuminate, tap or hold the UP arrow (
)
or the DOWN arrow (
) to change delay
stop timer at 0.5 hour increments up to
10 hours, then at 1 hour increments up to
24 hours. Then press the TIMER button to
conrm the setting (the control will conrm
the setting automatically after 5 seconds)
and go to delay start setting. Use the
same way as above to set the delay start
timing. If you don’t need to set delay start,
press the TIMER button again to exit. After
5 seconds, the control will automatically
change the display back to previous
temperature display. If you want to check
remaining time, press the TIMER button.
The delay start operation automatically
selects mode, temperature and fan speed
the same as last operation you set. To
activate the Timer function when the unit
is in Off mode, press TIMER button to rst
enter delay start and secondly enter delay
stop in the same way as above.
To cancel the timer setting, simply tap (
)
or (
) button to change the timing to 0.0.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Electrolux EXP12HN1WI at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Electrolux EXP12HN1WI in the language / languages: English, German, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 5,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Electrolux EXP12HN1WI

Electrolux EXP12HN1WI User Manual - German - 20 pages

Electrolux EXP12HN1WI User Manual - Dutch - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info