340838
6
Zoom out
Zoom in
Previous page
1/86
Next page
6
GB
Figure 5.
conditions of load and installation. If it is found
necessary to change the setting, the knob can be
turned to a higher number to give a lower temperature,
or a lower number to give a higher temperature. The
effect of any adjustment can be checked by means
of a thermometer when the refrigerator has reached
the new temperature after some hours.
“0”, disconnect the refrigerator from the electricity
supply and leave the cabinet door open. After
defrosting the cabinet interior should be wiped out
with a clean, damp cloth.
Figure 4.
6. Ice cubes
Fill the ice tray up to 4/5 with drinking water, and
place the ice tray on the ice-tray shelf. Wipe off
any excess water to prevent the ice tray from
freezing to the surface.
To speed up the making of ice cubes, turn the
thermostat to position 5 for a short while. Remember
to turn the dial to its normal setting when the ice
cubes are frozen.
To remove the cubes from the ice tray, hold it under
running water. The ice cubes can now be taken out
easily
7. Useful suggestion
Do not overfill the appliance. Put warm foods and
drinks in the appliance only when they have cooled
down to room temperature. It is advisable to leave
some space between the products in the cabinet to
ensure efficient and even cooling. If the shelves
are packed too tightly there may be unacceptable
temperature variations.
8. Defrosting, cleaning and
maintenance
This frost-formation is kept back by the FUZZY
LOGIC system built into the appliance.
The first defrosting phase commences 39 hours
after the start and lasts for two hours.
After this, the device operates for 22 hours at a
time, followed by a defrosting period of 2 hours.
The frost will melt and the defrost water will run
through the drain tube from the drip channel into an
evaporating vessel located at the bottom rear of the
refrigerator. (Fig 5) The defrost water will evaporate
automatically into the circulating air and the vessel
will not need emptying.
To switch off the unit, turn the thermostat knob to
9. Changing the lightbulb (If available)
If the lightbulb needs changing, pull out the plug and
proceed as follows:
Press the metal reflector to one side and draw the
lamp covering backwards. Replace the bulb and
push the covering back into place.
A new 10-watt bulb can be obtained at any service
shop.
10. Reversing the door hang
(Fig. 6)
Lay the appliance on its back. Remove the 8 screws
(1). Remove the door, together with the two hinges
(2), from the housing.
Remove the two cover caps (3) from the housing
and place them in the open hinge holes in the housing.
Place the bottom righthand hinge in the top left of
the door and the top righthand hinge in the bottom
left of the door and hang the door on its hinges in the
open cover cap holes in the housing. Secure the
hinges and cover caps with the 8 screws.
Check that the door closes easily and is sealed
properly.
Figure 6
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Electrolux ea 3120 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Electrolux ea 3120 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 0,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info