Manual Eldom RH01W (page 16 of 76) (English, German, Dutch, French)

782553

Zoom out

Zoom in

1/76

HOW TO USE THE APPLIANCE - Convector control board

Switching the convector heater On / Off;

„Settings“ menu - after pressing for 2 sec.

„Exit“ from „Settings“ menu

„-“ or Down;

„Sleep mode“ - after pressing for 2 sec.

„+“ or Up;

Delayed start - after pressing for 2 sec. while in Standby mode о

Extra heating - after pressing for 2 sec. while in Heating mode. The appliance operates at a temperature increased by 2.5 С

above the set temperature for one hour. Then the temperature is restored to the set temperature before the mode is enabled.

This mode is also disabled by pressing button 1.

„Information“

„Clear timers“ – after pressing for 2 sec.

„Confirmation“ (ОК) in „Settings“ menu

1 –

2 –

3 –

4 –

Symbols:

Clock

Internet

connection

Room

temperature

Date / Error

Messages

Operating

mode

Power

indicator

Set temperature /

Additional timer information /

Time to delay start

overheating protection

child protection

Appliance switching on and off

Switching the convector On is carried out by switching the key located on the right side panel (pressing the end of the key marked "I")

and then pressing the button 1 on the electronic control panel. Switching the appliance Off is carried out in the same way as using button

1 of the electronic control board and then pressing the key marked "0".

ATTENTION! The side panel switch and button 1 of the electronic control board are function keys. Complete turning off of the

appliance is carried out ONLY by taking the power supply cord out of the power supply socket.

Each time the appliance is switched on, on the graphic display for 2 seconds are shown the hardware and software versions. Then is

displayed the main screen with temperature, date, time, and additional information depending on the current operating mode. The

controller stores the last active operating mode for an unlimited period of time before shutting down the device and always starts with the

same when switched on again. The controller also has the ability to save information about system time, date, sleep mode, and delayed

start mode in cases of short-time power failures. Period of such data saving - up to 24 hours. (if the convector heater has been turned on

for at least 4 minutes) or up to 40 seconds (if it was switched on for a shorter time).

The device is preconfigured so that it enters in Heating mode when it is switched on for the first time.

LANGUAGE! The information can be displayed in different languages. Selecting a language is carried out from the sub-menu

Language » 2sec. ⏻ + ▼+ OK.

ATTENTION! It is imperative to set the time, date and the language initially!

By holding the button 1 for 2 seconds is displayed the main menu which means entering the Settings mode.

Navigate in the menu with the "▲" and "▼" buttons.

To enter the current settings, press the OK button. Once the screen with the relevant settings is displayed, the

individual parameters in it are corrected as follows:

The current parameter is displayed enclosed in a rectangle. With the "▲" and "▼" buttons, the parameters

set are crawled. Pressing the OK key enters the correction mode of the current parameter as its value is

displayed with a negative color in a filled rectangle.

Now with the "▲" and "▼" buttons you can change the value of the parameter. Once the required value is

selected, press the OK button to confirm the change and exit the parameter adjustment mode. An exception to

this rule are parameters as bookmarks (enabled / disabled). Instead, pressing the OK button changes the

status of the bookmark directly. Once all parameters have been set, the changes made are confirmed by

pressing button 1, and the controller returns to the main menu. For additional settings in the main menu, see

the "Controller Features" section.

open window detection

EN EN

XXXyy-XXX

SW ver yyy

HW ver yyy

T+ extra heating

1 2 3 4

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Eldom RH01W in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 7.3 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Eldom RH01W Manual

Product: