810943

EK63-EdilKamin Spot 100H Manual

13
Zoom out
Zoom in
Previous page
1/32
Next page
13
INSTALLATION
THE FLUE
THE FLUE
Further to the general prescriptions for the fumes
duct and fl ue, the fl ue
:
:
• must serve solely to exhaust fumes
• must be correctly sized to satisfy the requirements
of fumes exhaust (EN 13384-1)
• should preferably be insulated, in steel with
a circular internal section. If rectangular, the
corners must have a radius of not less than 20
mm, with a ratio of the internal dimensions of
<1.5
• must normally be at least 1.5 metres in vertical
length
• must have a constant cross section
• must be waterproof and thermally insulated to
ensure a good draw
• must preferable have a collection chamber for
uncombusted matter and condensation
• if pre-existing, must be clean, to prevent the fi re
hazard
• in general, we recommend fi tting a tube inside
the existing masonry chimney if its diameter is
greater than 150 mm.
INTUBATED SYSTEM
INTUBATED SYSTEM
Further to the general prescriptions for the fumes
duct and fl ue, the intubated system:
• must operate in negative pressure;
• must be open to inspection;
• must observe local regulations.
THE CHIMNEY POT
THE CHIMNEY POT
• must be windproof
• must have an internal cross section equivalent to
that of the fl ue and a fumes outlet at least double
that of the interior of the fl ue
• for dual fl ues (which should be spaced at least
2 m apart) the chimney pot receiving the fumes
from the solid fuel appliance or that from the
higher storey, must be at least 50 cm higher than
the other
• it must extend beyond the back fl ow zone (in
Italy, refer to UNI 10683 point 6.5.8.)
• it must allow for maintenance of the chimney.
COMBUSTION AIR INTAKE
In general, we suggest two ways to ensure a proper
fl ow of combustion air. The air must be drawn from
outside*
Please remember to also ensure air exchange for
heating and glass cleaning air, etc.
Indirect air intake
The boiler stove draws the air from outside through a
hole at the rear.
Install an air outlet at fl oor level with an eff ective
surface area (net of the screen or other protections)
of at least 80 cm2 (10 cm in diameter).
To prevent draughts, we recommend installing the
intake behind the product or behind a radiator.
Installing it in front of the appliance will create
unpleasant draughts.
Direct air intake **
Install an air intake of eff ective surface area (net of
the mesh or other protective equipment) equal to
the cross section of the air intake at the back of the
product.
Connect the air intake to the appliance’s air intake
with a tube (which may also be fl exible). Increase the
diameter of the pipe if the pipe is not smooth: assess
any load loss.
We recommend not exceeding a 3 m length, keeping
in mind the draw of the fl ue. For each curve, up to
a maximum of two curves, the length should be
reduced by 1 m. Assess whether or not to increase
the diameter of the pipe.
* The air maybe drawn from an adjacent room only if:
• the fl ow is taken from permanent and unobstructed
openings communicating with the outdoors;
• the air pressure in the adjacent room is never
lower than that of the outdoor pressure;
• the adjacent room is not a garage. subject to fi re
hazard, a bathroom or bedroom;
• the adjacent room is not a shared room in the
condominium.
In Italy, UNI 10683 provides that ventilation is
suffi cient even if a pressure diff erence between
the outdoors and indoors of no more than 4 PA is
guaranteed (UNI EN 13384-1). The installer who
issues the declaration of conformity is responsible for
ensuring these conditions.
** Direct connection to the air intake will not make
the product airtight. It is therefore necessary to
additionally ensure an air intake from within the room
where the product is installed (i.e. for glass cleaning).
… 13 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for EK63-EdilKamin Spot 100H at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of EK63-EdilKamin Spot 100H in the language / languages: English as an attachment in your email.

The manual is 2.19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of EK63-EdilKamin Spot 100H

EK63-EdilKamin Spot 100H Usermanual and installation guide - German - 32 pages

EK63-EdilKamin Spot 100H Usermanual and installation guide - French - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info