11
Remote control – Timer mode
With the device already operating, press the
“Timer” button – you can now set the time at
which the device switches off automatically. The
device will then run for the set time and then
switch off automatically. The setting for the
automatic switch-off time will be shown in the
LCD display on the remote control.
Each press of the “Temp/Time” button advances
the automatic switch-off time in 1 hour steps
within the range of 1 – 12 hours.
To cancel the automatic switch-off time, press the
“Timer” button again. The automatic switch-off
time will be cancelled.
With the device switched off, press the “Timer”
button – you can now set the time at which the
device switches on automatically. The device will
switch on automatically after the set time has
elapsed. The setting for the automatic switch-on
time will be shown in the LCD display on the
remote control.
Each press of the “Temp/Time” button advances
the automatic switch-on time in 1 hour steps
within the range of 1 – 12 hours.
To cancel the automatic switch-on time, press the
“Timer” button again. The automatic switch-on
time will be cancelled.
Important note: The switch-on time cannot be
programmed if the device is not connected to the
mains power supply.
Remote control – Setting the blowing direction
Press the ON/OFF button and switch on the
device.
Press the “Swing” button. The slats will swing in
the horizontal direction.
Once the slats have reached the desired position,
press the “Swing” button again. The slats will then
stay at the last position. If you press the button
again the slats will move again.
