the heater head (6) securely to the telescopic
tube (4) and extend it as far as possible. To do
so, first unscrew the locknut (5) and then tighten it
again.
7. Fig. 8: Carefully lay down the heater on the floor,
remove the strain-relief clips (f) on the bottom of
the base plate (1), guide the mains cable (7)
through the bottom parts of the strain relief clips
and retighten the strain-relief clips (f).
The heater is now fully assembled and ready for
operation.
7. Using the equipment
Important. Before using the equipment for the first
time, check that the voltage supply is the same as the
voltage details set out on the rating plate. Read the
safety regulations in section 1.
When the equipment is used for the first time or after
a long period of rest, it may emit an odor for a short
time. This is not a fault.
If black spots appear on the heating elements during
the first minutes of operation, this will affect neither
the quality nor performance of the heater.
7.1 Topple cut-out
The equipment has a topple cut-out. This will trip as
soon as the device is tipped beyond certain angle. It
will cut in again after the device has been placed
upright.
7.2 Heat output switches (Fig. 9):
Low heat output – activate switch (Item g)
Medium heat output – activate switch (Item h)
Maximum heat output – activate switch (Item g)
and (Item h)
8. Cleaning, maintenance and ordering
of spare parts
8.1 Cleaning
Before carrying out any cleaning and
maintenance work the equipment must be turned
off, disconnected from the power supply and
cooled down.
Maintenance and repair work may only be carried
out by an authorized electrical servicing
contractor or ISC GmbH.
Check the power lead at regular intervals for
signs of defects or damage. If the mains cable of
the equipment is damaged, it must be replaced
by a special power cable. If necessary please
contact your customer service center.
Use a damp cloth to clean the casing.
Remove dust pollution with a vacuum cleaner.
Never use combustible cleaning agents.
To remove dust on the safety grille and heating
elements, use a brush with long soft bristles.
In cases of very stubborn dirt the appliance
should be cleaned by a professional.
8.2 Servicing
There are no parts inside the equipment which
require additional maintenance. If the heating
elements have to be replaced, please contact your
customer service center.
8.3 Ordering spare parts
Please provide the following information on all orders
for spare parts:
Model/type of the equipment
Article number of the equipment
ID number of the equipment
Part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
9. Fault
In the event that the heating elements do not produce
heat, check if the equipment is switched on. If the
household fuse or e.I.c.b. has tripped, please ensure
that no other high-power devices are loading the fuse
in addition.
If the appliance still fails to work after you have
checked the above points, please contact your
customer service center (in Germany ISC GmbH).
10. Storage
Store the equipment and accessories out of children’s
reach in a dark and dry place at above freezing
temperature. The ideal storage temperature is
between 5 and 30 °C.
12
GB
