Manual Einhell MK 2300E (page 23 of 88) (English, German, French, Italian, Spanish)

724140

Zoom out

Zoom in

1/88

- 23 -

When the sleep function has been activated, the

fan will automatically run at low speed. The fan

speed cannot be changed.

5.8 Remote control

All modes and functions can be set using the

supplied remote control.

•

Use two alkali batteries, type R03 AAA (1.5 V)

(not supplied).

•

Never use a combination of new and used

batteries.

•

Never use a battery type other than the spe-

cified one.

•

If the remote control is not used for a lengthy

period of time, remove the batteries to pre-

vent them leaking.

•

Dispose of spent batteries properly.

•

Point the remote control towards the air-con-

ditioning system. The range is max. 5 meters.

•

Direct sunlight and objects can considerably

reduce the range of the remote control.

•

Handle the remote control with care. Do not

drop it and keep it away from heat and mois-

ture.

Inserting batteries

1. Open the battery compartment cover.

2. Insert two new batteries. Be sure to observe

the correct polarity (+/-) of the batteries.

Close the battery compartment cover.

5.9 SETTING THE AIR FLOW DIRECTION

The vertical direction of the air flow is determined

by the vertical ventilation grille. It has to be

adjusted by hand.

The horizontal direction of the air flow is

determined by the horizontal ventilation grille. It

has to be adjusted by hand.

5.10 Draining the condensate in the

condensate tray (Fig. 8)

For the cooling mode the device is fitted with

a condensate return unit. When the system is

in operation the condensate is collected in a

trough (approx. contents 0.85 liters) integrated

in the device. From there it is evaporated by the

condenser and transferred outside by the exhaust

air hose.

Note:

If the humidity in the room exceeds 85% (RH), a

condensate drainage hose (see section “5.11”) is

absolutely essential.

ALL OF THE CONDENSATE MUST BE

DRAINED OFF BEFORE YOU EVER

RELOCATE OR STOP USING THE DEVICE.

Note:

When the condensate tray is full the compressor

and the fan motor shut down. The “F.W.” LED

flashes and a signal sounds. The signal can be

disabled by pressing any button. The unit will

then be shut down completely.

When this happens, empty the tray as described

below:

Switch off the unit, pull the plug and do not

move the unit.

Push a container under the drain screw (1).

3. Unscrew the drain screw (1).

4. Remove the rubber bung (2) from the drain

opening (3).

The condensate runs into the container. If the

container is smaller than the condensate tray,

seal the drain opening (3) with the rubber

bung (2) and empty the container. Then

repeat the process from point 4.

Once the condensate tray has been

completely emptied, fit the bung (2) and the

drainage screw (1) again.

7. Start the unit again. The “F.W.” LED will no

longer flash.

5.11 Draining the condensate with a hose

(Fig. 8-10)

ALL THE CONDENSATE MUST HAVE

BEEN DRAINED BEFORE YOU START THE

FOLLOWING PROCESS.

Switch off the unit and pull the power plug.

2. Unscrew the drain screw (1).

3. Remove the rubber bung (2) from the drain

opening (3).

4. Connect the condensate drainage hose (4)

and secure it with a clip

5. The drainage hose can be extended with a

hose (5) with a diameter of 18mm. If you do

so, make sure you use a suitable connector.

Note:

The drainage hose must run to the outside with a

slight fall. The “Condensate tray full” indicator is

not operational.

Anleitung_MK_2100_E_SPK7.indb 23Anleitung_MK_2100_E_SPK7.indb 23 25.09.2018 10:12:4125.09.2018 10:12:41

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Einhell MK 2300E in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 1,41 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Einhell MK 2300E Manual

Product: