Manual Einhell GE-EM 1536 HW (page 27 of 114) (English, German, Dutch, French, Italian, Swedish, Spanish)

546966

Zoom out

Zoom in

1/114

- 27 -

Information on correct mowing

It is recommended that you overlap the mowing

swaths.

Only use a sharp blade that is in good condition.

This will prevent the grass blades from fraying

and the lawn from turning yellow.

Try to mow in straight lines for a nice, clean look.

The swaths should overlap each other by a few

centimeters in order to avoid stripes.

How frequently you should mow your lawn de-

pends mainly on the speed at which the grass

grows. In the main growing season (May - June)

you will probably need to mow the lawn twice

a week, otherwise just once a week. The cut-

ting height should be between 4 - 6cm and the

amount of growth before mowing again should be

4 - 5cm. If the grass is allowed to grow somewhat

longer for whatever reason, do not make the mis-

take of cutting it back to the normal height in one

go. This will harm the lawn. Never cut it back by

more than half the height in one go.

Keep the underside of the mower housing clean

and remove grass build-up. Deposits not only

make it more diﬃ cult to start the mower; they

decrease the quality of the cut and make it harder

for the equipment to bag the grass.

Always mow along inclines (not up and down).

You can prevent the lawn mower from slipping

down by holding a position at an angle upwards.

Select the cutting height according to the length

of the grass. Make several passes so that no

more than 4 cm of grass are cut at one time.

Switch oﬀ the motor before doing any checks on

the blade. Keep in mind that the blade continues

to rotate for a few seconds after the motor has

been switched oﬀ .

Never attempt to stop the blade. Regularly check

to see if the blade is securely attached, is in good

condition and is sharp. If the contrary is the case,

sharpen the blade or replace it. In the event that

the blade strikes an object, immediately switch

oﬀ the lawn mower and wait for the blade to come

to a complete stop. Then inspect the condition of

the blade and the blade mount. Replace any parts

that are damaged.

Lay the power cable on the ground in loops in

front of the power outlet. Mow away from the po-

wer outlet and cable, making sure that the power

cable always trails in the mowed grass so that the

lawn mower does not travel over the cable.

As soon as grass clippings start to trail the lawn

mower, it is time to empty the grass basket.

Important! Before taking oﬀ the grass basket,

switch oﬀ the motor and wait until the blade has

come to a stop.

To take oﬀ the grass basket, use one hand to lift

up the chute ﬂ ap and the other to grab onto the

basket handle. Remove the basket. For safety

reasons, the chute ﬂ ap automatically drops after

removing the grass basket, closing oﬀ the rear

chute opening. If any grass remains in the ope-

ning, it will be easier to restart the motor if you pull

the mower back approximately 1m.

Do not use your hands or feet to remove clippings

in or on the mower housing, but instead use suita-

ble tools such as a brush or a broom.

In order to ensure that the majority of grass clip-

pings are picked up, the inside of both the grass

basket and especially the net must be cleaned

after each use.

Reattach the grass basket only when the motor is

switched oﬀ and the blade has stopped.

Lift up the chute ﬂ ap with one hand and, holding

the grass basket by its handle with the other

hand, hang in the basket from the top.

7. Replacing the power cable

If the power cable for this equipment is damaged,

it must be replaced by the manufacturer or its

after-sales service or similarly trained personnel

to avoid danger.

Anl_GE_EM_1536_HW_M_SPK7.indb 27Anl_GE_EM_1536_HW_M_SPK7.indb 27 31.07.13 15:4831.07.13 15:48

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Einhell GE-EM 1536 HW in the language / languages: English, German, Dutch, French, Italian, Swedish, Spanish as an attachment in your email.

The manual is 2,55 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Einhell GE-EM 1536 HW Manual

Product: