644151

Efco TG2650XP Manual

18
Zoom out
Zoom in
Previous page
1/48
Next page
18
25 26
Italiano English Français
AVVIAMENTO STARTING MISE EN ROUTE
ATTENZIONE: osservare le istruzioni di sicurezza per
la manipolazione del carburante. Spegnere sempre il
motore prima di fare rifornimento. Non aggiungere mai
carburante a una macchina con il motore in funzione
o caldo. Spostarsi almeno 3 m dalla posizione in cui
è stato e ettuato il rifornimento prima di avviare il
motore (Fig.25). NON FUMARE!
1. Pulire la super cie attorno al tappo del carburante per
evitare contaminazioni.
2. Allentare lentamente il tappo del carburante.
3. Versare con attenzione la miscela di carburante nel serbatoio.
Evitare versamenti.
4. Prima di rimettere il tappo del carburante, pulire e controllare
la guarnizione.
5. Rimettere immediatamente il tappo del carburante
stringendolo manualmente. Rimuovere eventuali versamenti
di carburante.
ATTENZIONE: controllare se vi sono perdite di
carburante e, ove presenti, eliminarle prima dell’uso.
Se necessario, contattare il servizio assistenza del
proprio rivenditore.
Motore ingolfato
- Posizionare l’interruttore di massa su STOP.
- Applicare uno strumento idoneo al cappuccio della
candela (1, Fig. 26).
- Sollevare il cappuccio della candela.
- Svitare e asciugare la candela.
- Aprire completamente la farfalla.
- Tirare diverse volte la fune di avviamento per svuotare la
camera di combustione.
- Riapplicare la candela e collegare il cappuccio premendolo
con decisione.
- Posizionare l’interruttore di funzionamento su I, posizione
di avviamento.
- Portare la leva starter nella posizione OPEN, anche se il
motore è freddo.
- Avviare ora il motore.
WARNING: Follow safety instruction for fuel handling.
Always shut o engine before fuelling. Never add fuel
to a machine with a running or hot engine. Move at
least 3 m from refuelling site before starting engine
(Fig.25). DO NOT SMOKE!
1. Clean surface around fuel cap to prevent contamination.
2. Loosen fuel cap slowly.
3. Carefully pour fuel mixture into the tank. Avoid spillage.
4. Prior to replacing the fuel cap, clean and inspect the
gasket.
5. Immediately replace fuel cap and hand tighten. Wipe up
any fuel spillage.
WARNING: Check for fuel leaks, if any are found, correct
before use. Contact a Servicing Dealer if necessary.
Engine is Flooded
- Set the on/off switch to STOP.
- Engage a suitable tool in the spark plug boot (1, Fig. 26).
- Pry off the spark plug boot.
- Unscrew and dry off the spark plug.
- Open the throttle wide.
- Pull the starter rope several times to clear the combustion
chamber.
- Refit the spark plug and connect the spark plug boot,
press it down firmly.
- Set the on/off switch to I, the starting position.
- Set the choke lever to OPEN position – even if engine is
cold.
- Now start the engine.
ATTENTION : respectez les consignes de sécurité sur la
manipulation du carburant. Coupez toujours le moteur
avant de procéder au ravitaillement. Ne faites jamais
l'appoint de carburant lorsque le moteur tourne ou s'il
est encore chaud. Restez à au moins 3 m de la zone de
ravitaillement avant de démarrer le moteur ( g.25).
NE FUMEZ PAS !
1. Nettoyez la surface autour du bouchon de carburant a n
d'éviter toute contamination.
2. Dévissez lentement le bouchon de carburant.
3. Versez soigneusement le mélange de carburant dans le
réservoir. Évitez de renverser du carburant.
4. Avant de remonter le bouchon de carburant, nettoyez et
inspectez le joint d'étanchéité.
5. Remontez immédiatement le bouchon de carburant et
serrez-le manuellement. Essuyez tout déversement de
carburant
ATTENTION : véri ez si le carburant fuit et, le cas
échéant, éliminez les fuites avant d'utiliser la machine.
Si nécessaire, faites appel au service d'assistance
auprès de votre revendeur.
Moteur noyé
- Basculez l’interrupteur de marche/arrêt sur la position
STOP.
- Insérez un outil adapté dans la coiffe de bougie
(1, Fig. 26).
- Faites levier sur la coiffe de bougie et retirez-la.
- Dévissez et séchez la bougie.
- Ouvrez l’accélérateur à fond.
- Actionnez le lanceur à plusieurs reprises de façon à vider la
chambre de combustion.
- Remontez la bougie et connectez la coiffe en l’enfonçant
fermement.
- Basculer l’interrupteur de marche/arrêt sur I, la position de
démarrage.
- Passez le levier d’étrangleur sur la position OUVRIR, même
si le moteur est froid.
- Démarrez à présent le moteur.
… 18 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Efco TG2650XP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Efco TG2650XP in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 1,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info