Manual Edilkamin Kelly (page 31 of 208) (English, German, Dutch, French, Italian, Spanish)

810817

Zoom out

Zoom in

1/208

ENGLISH

PRINCIPLE OF OPERATION

TINY - KELLY stoves heat the air using wood pellets as fuel,

with electronically controlled combustion. Hereunder is the

explanation of its functions (the letters refer to figure 1).

The fuel (pellets) is provided by the storage hopper (A) and,

to the combustion chamber (D) by means of a feed screw (B),

which is driven by a gear motor (C).

The pellets are ignited by the air that is heated by an elec-

trical resistance (E) and drawn into the combustion cham-

ber by a smoke extractor (F).

The fumes produced during the combustion process are

extracted from the hearth by the same centrifugal fan (F),

and expelled through the outlet (G) located on the lower

part of the stove.

The stoves are designed to allow warm air to be channelled,

to heat an adjacent room.

Three outlets are set up to channel warm air (on the rear,

side and top). Use the most suitable one (hence the caps will

have to be used to close off the other outlets) connecting it

with the specifically-designed optional KIT 8.

The hearth is lined with cast iron, closed in the front by two

overlapping doors.

- a ceramic glass external door (use the special thermal

glove to open the stove).

- an inner door made from ceramic glass which is in direct

contact with the fire. The amount of fuel, smoke extraction,

and air - fuel supply are all controlled by the software-

equipped circuit board, with the aim of obtaining highly

efficient fuel consumption and low emissions.

All phases of operation can be managed via radio remote

control (provided with the Tiny model).

Whereas the Kelly model has a synoptic panel (M) installed

on the lefthand side, which allows you to control and view

all phases of operation.

An optional remote control to manage the main functions is

available for the Kelly model.

The stove is equipped with a serial port to connect an optio-

nal cable (TINY cod. 621240 - KELLY cod. 620550) to be

connected to devices that allow remote ignition (e.g. remo-

te telephone, local thermostat).

SAFETY INFORMATION

The TINY - KELLY stoves are designed to provide hea-

ting, by automatically burning pellets in the hearth, in the

room where they are installed, as well as radiate heat and

circulate air coming out of the front grille, and in the adja-

cent room by circulating channelled air from the rear, right

side or top outlet.

• The only risks that may derive from using the stove

pertain to non-compliance with installation instructions,

direct contact with live electrical parts (internal), contact

with the fire or hot parts (glass, pipes, hot air output), or

foreign substances being put in the stove.

• Only use wood pellets with 6 mm diameter as fuel.

• Should components fail, the stoves are equipped with

safety devices that guarantee automatic shutdown. These

are activated without any intervention required.

• In order to function correctly, the stove must be instal-

led in accordance with the instructions given herein and

the door must not be opened during operation: combu-

stion is fully automatic and requires no intervention.

• Under no circumstances should any foreign substances

be entered into the hearth or hopper.

• Do not use flammable products to clean the smoke

channel (the flue section connecting the stove smoke

outlet to the chimney flue).

• Hearth and hopper components must only be cleaned

with a vacuum cleaner.

• The glass can be cleaned when COLD with a suitable

product (e.g. GlassKamin Edilkamin) and a cloth.

• Do not clean when hot.

• Ensure that the stoves are installed and ignited by a

qualified Edilkamin DEALER, in accordance with the

instructions given herein.

• When the stove is in operation, the exhaust pipes and

door become very hot (do not touch without wearing the

thermal glove).

• Do not place anything, which is not heat resistant near

the stove.

• NEVER use liquid fuel to ignite the stove or rekindle

the embers.

• Do not obstruct the ventilation apertures in the room where

the stove is installed, nor the air inlets of the stove itself.

• Do not wet the stove and do not go near electrical parts

with wet hands.

• Do not use reducers on the smoke exhaust pipes.

• The stove must be installed in a room that is suitable

for fire prevention and equipped with all that is required

(power and air supply and outlets) for the stove to fun-

ction correctly and safely.

• Should ignition fail, DO NOT re-ignite until you have

emptied the combustion chamber.

•ATTENTION: THE PELLET EMPTIED FROM

THE COMBUSTION CHAMBER MUST NOT BE

DEPOSITED INSIDE THE HOPPER.

fig. 1

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Edilkamin Kelly in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 8.89 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Edilkamin Kelly Manual

Product: