499659

Edilkamin IDROTECH Manual

35
Zoom out
Zoom in
Previous page
1/115
Next page
- 35 -
ADVICE IN THE EVENT OF PROBLEMS
PROBLEM CAUSE SOLUTIONS
display-control panel off no mains voltage Check power cord connection
Check fuse (on power cord)
Check at cable connection to display-control
panel
remote control not working
excessive distance from stove move nearer to stove
remote control batteries at check and change if necessary
Water not hot too much soot in heat exchanger clean heat exchanger from inside the rebox
The chimney pots and smoke ducts connected to solid fuel devices must be brushed once a year (check whether there are regu-
lations on the subject in the country of installation). If inspection and regular cleaning are not carried out, the probability of a
chimney pot re increases. In the event of a chimney pot re, proceed as follows: do not use water to extinguish; empty the pellet
hopper; contact specialist staff after the accident before starting up again.
POSSIBLE CAUSES OF SHUTDOWN
If the stove shuts down, the reason is shown on the display.
1) Broken PTC H20: shutdown due to water temperature detector failure or disconnection.
2) No expulsion: shutdown due to a fault detected by the smoke exhaust motor sensor.
3) No re: shutdown due to a drop in smoke temperature.
4) No start: shutdown due to incorrect smoke temperature during ignition.
5) Power failure: shutdown due to power failure.
6) Termoc broken: shutdown due to thermocouple failure or disconnection.
7) Over temp: shutdown when the maximum smoke temperature set is exceeded.
8) H2O temp alarm: shutdown due to a water temperature of above 90°C.
9) No depression: shutdown due to low pressure.
The message is displayed until the 0/1 key on the panel is pressed.
Do not restart the stove until the problem has been looked into and the cause removed.
To start the stove up again after a shutdown, let the shutdown procedure end (10 minutes marked by a beep) then press the 0/1
key.
Never unplug the stove while it is shutting down due to problems.
It is important to report what the panel says to the DEALER.
ADVICE IN THE EVENT OF PROBLEMS
1) Broken PTC H20 (this trips if the water temperature detector fails or is disconnected).
Check connection between the detector and the circuit board. Check operation with cold tests
2) No Expulsion (this trips if the smoke extraction speed sensor detects a fault).
- Check smoke extractor operation (speed sensor connection).
- Make sure the smoke duct is clean.
3) No re (this trips if the thermocouple detects a smoke temperature lower than the value set, which it interprets as the
absence of ames).
There may be no ames because
- there are no pellets.
- too many pellets have smothered the ames.
- the maximum thermostat/pressure switch/water safety thermostat has tripped to “stop” the gearmotor.
4) No start (this trips if no ames appear and the start-up temperature is not reached within a maximum of 15 minutes).
ENGLISH
ENGLISH
… 35 …


Need help? Post your question in this forum.

Forumrules
1

Forum

edilkamin-idrotech

Reset search

  • quando la stufa non é funzionante nel display esce la scritta "bat 1" e lampeggia. qual'é il motivo? Submitted on 30-3-2022 at 15:44

    Reply Report abuse

    • Prova a cambiare la batteria del CMOS e tipo quella del telecomando della machina se non sbaglio 3510 Answered on 24-9-2022 at 01:04

      Vote up Report abuse

  • avendo un impianto piccolo vorrei attivare la funzione eco nella mia stufa idrotech come si fa? Submitted on 7-11-2021 at 19:54

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Edilkamin IDROTECH at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Edilkamin IDROTECH in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 4,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info