499659
25
Zoom out
Zoom in
Previous page
1/115
Next page
- 25 -
The electrical system must comply with the law; in particular make sure the earth circuit is
in working order.
The power supply line must have a suitable cross-section for the equipment rating.
LOCATION
For correct operation the stove must be level.
Check the load-bearing capacity of the oor.
FIRE SAFETY DISTANCES
The stove must be installed in compliance with the following safety conditions:
- minimum safety distance at the sides and back from medium-level ammable mate-
rials: 40 cm.
- easily ammable materials must not be located less than 80 cm from the front of the
stove.
- if the stove is installed on a ammable oor, a sheet of heat insulating material must
be placed between the stove and the oor, which protrudes by at least 20 cm at the sides
and 40 cm at the front. Objects made of ammable materials must not be placed on the
stove or at less than the safety distance from it. If the smoke outlet pipe is connected
to walls made of wood or other ammable materials, it must be insulated with ceramic
bre or other materials with similar characteristics.
AIR INTAKE
The room where the stove is located must have an air intake with cross section of at
least 80 cm2 to ensure replenishment of the air consumed by combustion
SMOKE OUTLET
The stove must have its own smoke outlet (it must not discharge into ues shared
with other devices).
The smoke leaves the stove through the 8 cm diameter pipe at the back. A T-section with
condensation trap and bleeder must be tted at the beginning of the vertical section. The
stove smoke outlet must be connected with the outside using black painted or steel pipes
(resistant to 450°C), without obstructions.
The pipe seals must be air-tight. To seal and insulate (if necessary) the pipes, material
that withstands up to 300°C must be used (silicone or high temperature mastic).
The horizontal sections may be up to 2 m long. The horizontal sections must have a mini-
mum upward gradient of 3%. Up to two 90° bends may be included.
If the smoke outlet does not end in a ue, a vertical section with wind guard at the end is
essential.
The vertical duct section may be indoor or outdoor. If the smoke duct is outdoor, it must
be insulated.
If the smoke duct ends in a ue, the ue must be authorized for solid fuel. If it is more
than 150 mm in diameter, it must be renewed by inserting an internal pipe and sealing the
smoke outlet from the brickwork. All sections of the smoke duct must be inspectable. If
it is xed, cleaning inspection openings must be provided.
Recommended installations are shown in the following gures.
ASSEMBLY AND INSTALLATION (DEALER)
Refer to the local regulations in the country of use for anything not expressly shown. In Italy, refer to Italian standard 10683/2005
or later modications, and Italian law No. 46/90, along with any regional or local health authority regulations.
If the stove is to be installed in a block of ats, consult the block administration before installing.
COMPATIBILITY CHECK WITH OTHER DEVICES
According to Italian standard UNI 10683/2005, the stove must NOT be installed in the same room as extractor fans, type A and B
gas equipment, or devices which lower the pressure in the room.
ELECTRICAL CONNECTION CHECK
(PUT THE PLUG IN AN ACCESSIBLE PLACE)
The stove is tted with an electrical power cord for connection to a 230 V 50 Hz socket, preferably protected with a thermal-
magnetic circuit breaker. Voltage variations of greater than 10% may impair stove operation (if not already installed, t a suitable
residual current circuit breaker).
ENGLISH
ENGLISH
safety distance from ammable materials
oor protection sheet
A: insulated steel ue
B: 1.5 m minimum height
C-E: air intake from inside room (minimum
internal section: 80 cm²)
D: steel ue, inside existing brick-built chimney
25


Need help? Post your question in this forum.

Forumrules
1

Forum

edilkamin-idrotech

Reset search

  • quando la stufa non é funzionante nel display esce la scritta "bat 1" e lampeggia. qual'é il motivo? Submitted on 30-3-2022 at 15:44

    Reply Report abuse
    • Prova a cambiare la batteria del CMOS e tipo quella del telecomando della machina se non sbaglio 3510 Answered on 24-9-2022 at 01:04

      Vote up Report abuse
  • avendo un impianto piccolo vorrei attivare la funzione eco nella mia stufa idrotech come si fa? Submitted on 7-11-2021 at 19:54

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Edilkamin IDROTECH at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Edilkamin IDROTECH in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 4,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info