810888
13
Zoom out
Zoom in
Previous page
1/44
Next page
13
ENGLISH
WATER CIRCUIT INSTALLATION
PLUMBING
The products are equipped with closed expansion
tanks.
If the expansion tank is built into the product, this
does NOT ensure proper protection against thermal
expansion caused by water in the entire system.
Therefore, installers should assess whether an
additional expansion tank is needed, depending on the
type of system.
ALL OTHER HYDRAULIC COMPONENTS MAY BE
INSTALLED WITHIN THE Boiler stove BY PURCHASING
A KIT OR IF PREPARED BY THE INSTALLER.
Plumbing depends on the type of system.
However, there are some “general rules”:
The hydraulic system must operate at a pressure
between 1 and 1.5-2 bars at running temperature
(hot) in a closed vessel circuit.
N.B.: The boiler stove SHOULD NOT be installed
in place of, for example, an open vessel installed
kitchen range without adjusting the expansion
system to closed vessel.
The presence of an accumulator (tank) is
recommended but not mandatory. Its advantage
is that it releases the boiler stove from “sudden”
requests from the system and can be integrated
with other heat sources. It reduces fuel consumption
and increases the efficiency of the system. A puffer
of at least 20 l/kW is recommended.
The return temperature of water to the boiler stove
must be higher than 50-55° C to prevent the forming
of condensation.
An accumulator (tank) is needed to heat
lowtemperature radiant panels and must be installed
according to the panel manufacturer’s instructions.
The material used in the circuit must be suitable to
withstand overheating.
The installer must determine whether or not to use
conditioned products. In Italy, refer to UNI 8065-1989
(Water treatment in heating systems for civil use).
Direct plumbing to the radiators prevents proper
operation, owing to the small diameter of their pipes.
We offer four internal kits (optional)
KIT R-FX
for installation without instant DHW production.
KIT R2-FX
For installation without instant DHW production with
system separator.
KIT RW-FX
for installation with instant DHW production Suggested
for 22 kW models only.
PRESS URE GAUGE
The boiler stoves have an electronic water pressure
gauge. There are no analogue pressure gauges.
The water pressure is shown on the display, (*) as
shown
in the diagram. An analogue pressure gauges can be
fitted as an optional extra.
VENT
During normal operation the stove is
vented automatically. The need for manual
venting can only be assessed at initial
start-up by the technician
make sure that the swivel (nut)
on the two boiler stove outlet
pipes is closed
The product looks like the image below without any
kits.
(*)
Real size templates are available for technicians.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Edilkamin GORA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Edilkamin GORA in the language / languages: English as an attachment in your email.

The manual is 1.3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Edilkamin GORA

Edilkamin GORA User Manual - German - 44 pages

Edilkamin GORA Usermanual and installation guide - German - 40 pages

Edilkamin GORA Usermanual and installation guide - French, Italian - 80 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info