Manual Edilkamin Daisy (page 19 of 28) (English)

810907

Zoom out

Zoom in

1/28

ENGLISH

Filling the cochlea.

The first time you use the product, or should the tank

be completely emptied of pellets, to fill the coclea press

both keys “+” and “–” on the remote control at the

same time, holding for a few seconds. As you release

the keys, the display should show the wording “LOAD”.

This should be carried out before ignition if the boiler-

stove has stopped due to having run out of pellets,

at the end of operation to empty the combustion pot

before turning.

It is quite normal for some pellets to remain, that the

cochlea cannot suction.

Automatic igniting.

With the boiler-stove on stand-by, press and hold the

key , on the remote control for 2 seconds. This will

start-up the ignition procedure, showing the wording

“START”.

At the same time, a countdown in seconds begins (from

1020 to 0). Ignition is not at a preset time, however: its

duration is automatically shortened if the board reports

that certain tests have been passed. The flame appears

after about 5 minutes.

Manual igniting.

Temperatures of below 3°C will not allow the electrical

resistance to heat sufficiently. In this case, or should the

resistance be temporarily out of action, Diavolina® type

fire-starters can be used.

Insert a piece of lit Diavolina into the combustion cham-

ber, close the door and press the remote control.

OUTPUT TEMPERATURE ADJUSTMENT:

The SET output temperature can be altered by pressing

the keys +/-.

ENVIRONMENT TEMPERATURE ADJUSTMENT:

By activating the COMFORT CLIMA (CAT) function with

the +/- keys, the remote control device can be used

as a mobile thermostat/chronothermostat: place it in

the home in a position where the set temperature is

desired, select COMFORT CLIMA with the menu key;

the display will show the environmental temperature

(AIR) and the desired environmental temperature (SET);

adjust the desired temperature with the +/- keys and

the remote control dev¬ice will automatically send the

request to the stove.

Turning off

With the boiler-stove running, press and hold the key

rom the remote control for 2 seconds. The turn-

off procedure will begin, showing a countdown on the

display from 9 to 0 (for a total of 10 minutes).

The turn-off phase involves:

• Interruption of pellet supply

• Smoke expulsion motor

• Circulator

Unless otherwise set, managed by the CAT.

Never pull the plug out whilst the device is still in the

process of turning off.

N.B.: the circulator will continue turning for 5 - 10 minu-

tes after switching off.

OPERATIONS THAT CAN ONLY BE CARRIED OUT

BY REMOTE CONTROL

Clock regulation

Press and hold the key “M” for 2 seconds to access the

“Clock” menu. This allows you to set the internal electronic

board

clock. By then pressing the key “M”, the following data appe-

ars in sequence and can be regulated:

day, month, year, hour, minutes, day of the week.

The wording “SAVE??” will appear for confirmation with “M”.

This will allow you to check that the operations performed

are correct, prior to completion (the wording “SAVE” will then

be shown on the display).

Operations for switching on, switching off and changing the

SET temperature can be carried out by means of the red

emergen¬cy button placed on the back of the boiler-stove

(see page 50).

Weekly timer

Press and hold the “M” key on the remote control for 2

seconds. This turns on the clock regulation and by pressing

the ‘+’

key, the weekly timer function is accessed, with the display

showing the description “PROGRAMM ON/OFF”.

This function allows you to select the type of programming,

which allows a maximum of three ignitions to be set.

As you confirm the display with the key “M”, one of the fol-

lowing options will appear:

NO PROG. (no programme set)

DAILY PROGRAM (single programme for every day of the

week)

WEEKLY PROGRAM. (specific programme for each day

individually)

Use the “+” and “–” keys to switch between programmes.

Confirming by pressing the “M” key “DAILY PROGRAM.” and

pressing the “+” key, the choice of the number of program-

mes (ignition/extinguishing) per day can be made.

Use the “DAILY PROGRAM” to set identical programme/s for

every day of the week.

By then pressing the “+” key, the following can be seen:

- Prog. no.

- 1st prog. (one turn on and one turn off per day), 2nd prog.

(identical), 3rd prog. (identical)

Use the “–” key to show in reverse order.

If the 1st programme is selected, the turn on time is shown.

The display shows: 1 “ON” at 10 Use the “+” and “–” key

to change the hour. Confirm with the “M” key (All 1 On/Hour

10).

The display shows: 1 “ON” at 30 Use the “+” and “–” key to

change the minutes. Confirm with the “M” key (1 Off min).

The same applies for the turn-off time to be set and for

subsequent turning on and off.

Confirm by pressing “M” and the wording “SAVE??” will

appear on the display.y.

When confirming ”WEEKLY PROGRAM”, you will need to

choose the day to which the programming is to apply:

7 Sat; Progr.1; 1 Mon ; 2 Tues; 3 Wed; 4 Thurs; 5 Fri; 6 Sa;

Once the day is set, use the keys “+” and “+” and con-

firm by pushing the “M” key to choose 1 to 3 ignitions, to

programme in the same way as for the “DAILY PROGRAM”,

choosing whether or not to enable a programme for each

day of the week, and if so choose the number of interven-

tions and at what times.

Should you make an error during programming, you can lea-

ve the programme without saving. As you press a key, ,

the display will show the word “no SAVE”.

USER INSTRUCTIONS

USER

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Edilkamin Daisy in the language / languages: English as an attachment in your email.

The manual is 5.34 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Edilkamin Daisy

Edilkamin Daisy Usermanual and installation guide - German - 28 pages

Edilkamin Daisy Usermanual and installation guide - Dutch - 28 pages

Edilkamin Daisy Usermanual and installation guide - French, Italian - 52 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Edilkamin Daisy Manual

Product: