647413

Ecm Barista Profi Manual

15
Zoom out
Zoom in
Previous page
1/34
Next page
ENGLISH
Instruction manual BARISTA · BARISTA PROFI
14
6 First use
Before starting the machine, please check if
• the brew group lever is in the lower position.
• the steam and hot water valves are closed.
• the power switch is off (lever in position “0”).
• the power cord is disconnected.
• the drip tray is inserted accurately.
Now you can start up your machine:
1 Take off the cup heater tray. Remove silicone hose from the water tank and put it aside.
2 Take out the water tank and clean it carefully. Then reinsert it and replace the silicone hose into the water tank.
3 Fill the water tank with fresh water, preferably deficient in lime. Replace the cup heater tray.
4 Insert the power plug into the wall socket. Turn the power switch to “1”. The machine is now on.
5 The green control lamp lights up.
6 The pump will fill the boiler of the machine with fresh water.
7 As soon as the boiler is filled, there will be no more pump noise; the orange control lamp is now on. As soon as
the fresh water sinks down to a certain level in the fresh water tank, the machine is switched off and the light of
the orange control lamp switches off. Now refill fresh water. The machine heats up automatically.
8 Because a large amount of water is required for the first filling of the boiler, the water tank has to be refilled with
fresh water.
9 Wait until the boiler pressure gauge indicates approx. 1.0 bar.
10 A manual “boiler ventilation” is not necessary because the BARISTA / BARISTA PROFI is equipped with a
professional depression valve that ventilates the boiler during the heat-up phase.
11 Move the group lever into the upper position and dispense approx. 250 ml of water. This way, the heat exchanger
will be filled with water and the circulation of the water in the thermosyphon system begins.
12 Move the brew group lever into the lower position and refill the water tank.
13 The machine is now ready for use. Put the cups on the cup heater tray in order to preheat them.
Advice: If the boiler filling phase is longer than 3 minutes, the machine switches to the stand-by mode. In this case,
please switch off the machine, then switch it on again.
7 Daily use
The switched off machine is to be placed into operation as follows:
1 Make sure there is sufficient water in the water tank.
2 Turn the machine on (power switch in position “1”).
3 Wait until the pressure gauge indicates approx. 1.0 bar.
4 Depending on the ambient temperature, the heat-up phase is approx. 15 minutes.
5 The machine is now ready for use.
6 Insert the filter holder, move the group lever into the upper position and release some hot water. This way, the
filter holder will be completely heated.
8 Preparing coffee
Use the filter holder with 1 spout and the corresponding filter (1 cup) for the preparation
of 1 cup. Use the filter holder with 2 spouts and the big filter (2 cups) for the
preparation of 2 cups. Make sure that the filter is firmly locked into the filter holder.
Fill the finely ground coffee into the filter.
Use 1 level measuring-spoon of coffee for each cup (approx. 7 g).
Do not overfill the measuring-spoon, as shown in the figure on the right side!
Compress the ground coffee with the tamper. Clamp the filter holder firmly into the brew group.
Only freshly ground coffee allows for an optimal coffee result. Therefore, use a professional coffee grinder. In our
assortment you will find several professional and compact coffee grinders.
… 15 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ecm Barista Profi at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ecm Barista Profi in the language / languages: English, German as an attachment in your email.

The manual is 5,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info